VG/PG ratio for certain atomizers

[Mden89]

So i want to get some great vapor production, but i dont want to ruin my atomizer with too high of a VG content.

My two setups:

eleaf Istick 20w with nautilus Mini (1.6-1.8ohm atty)

Kanger sub box mini with kanger subtank mini (.5 atty RBA)

Whats the highest VG content i can use for both of these?

Also, whats the highest VG content you can use for dripping with a rda?

 

[cckayne]

I can only talk about the Nautilus because that's the clearo I use. Most tanks are very sensitive to the PG/VG ratio: Too much VG and they'll fail to wick quickly enough between puffs. After extensive experimentation, I've found the optimal mix ratio for my BVC coils to be 60-40 PG/VG. This invariably gives great vapour production, good taste and a minimum of dry/scorched hits. YMMV.

 

[sketchness]

you can easily use 80vg with the mini. just add about 3 drops of distilled water per tank. atomizers go a little quick with the heavier liquid. Like around 5 days.

Cant speak to the kanger. But my Atlantis I can vape straight vg at 35 watts no problem. 80/20 was a breeze. No burnt ones unless i cranked it up around 45 and chain vaped.

 

[dannyv45]

You can use VG with any atomizer. It all depends on how much DW you use to dilute it. It's should be delute enough to be the same consistance as PG.

 

[cckayne]

I'd never add water unless I were prone to PG allergies, which most people are not. PG aids in carrying the flavour and provides somewhat of a throat-hit.

 

[Mden89]

I think the highest ill go is 70/30 in my Naut mini setup. But when i drip i think ill try maxing out VG a few times to compare

 

[chopdoc]

I just picked up the Kanger mini subtank yesterday and was watching some youtube vids on it and seen it was recommended to dont go over 70VG/30PG. I ran 12 ml of unicorn milk thru it yesterday at that percentage with no problems. At the moment I have some DIY juice in it that is 80VG/20PG and it seems to be wicking fine.

Cant tell you about the naut mini, never used one.