Hi here,
May I know if any brother here have experience to use mods with VO chip in TC?
My story is:
I have just get my first VO Chip mods, and I found that it always cannot read the correct resistance for different coil:
SS Wire:
VO Chip reads it is 0.69Ohm but on my other SX 350J mods, it read 0.95
Ni Wire:
VO Chip detect it has been short circuit and under SX350J, it is 0.06
Ti Wire:
VO Chip read it is 0.6Ohm but on SX350J, it should be 0.21
But for normal Power mode, with Kanthal A1, the reading is the correct on VO with same reading as on SX350.
Just want to see if that's the chip issue.
May I know if any brother here have experience to use mods with VO chip in TC?
My story is:
I have just get my first VO Chip mods, and I found that it always cannot read the correct resistance for different coil:
SS Wire:
VO Chip reads it is 0.69Ohm but on my other SX 350J mods, it read 0.95
Ni Wire:
VO Chip detect it has been short circuit and under SX350J, it is 0.06
Ti Wire:
VO Chip read it is 0.6Ohm but on SX350J, it should be 0.21
But for normal Power mode, with Kanthal A1, the reading is the correct on VO with same reading as on SX350.
Just want to see if that's the chip issue.
