Wanting small tank for ego with RBC, around 1.5ml

[charly1954]

I've looked around and can't find any real small tank/clearomizer with replaceable bottom coil. All the small ones I find are top coil or not coil replaceable. I got a Kanger T3S today thats 3ml, came with the bat and I don't like the length. I am wanting something around 1.5ml so the setup is shorter.

 

[bm2112]

Kanger Mini Protank 2&3
Kanger Mini Aerotank

Both are replaceable bottom coils with good performance. I have mech/rda setup as my main but my backup is just an Ego twist and a Mini PT3.

 

[mmsjs5]

I've looked around and can't find any real small tank/clearomizer with replaceable bottom coil. All the small ones I find are top coil or not coil replaceable. I got a Kanger T3S today thats 3ml, came with the bat and I don't like the length. I am wanting something around 1.5ml so the setup is shorter.

I have several of the mini T3S's. Love em and they use the same replaceable coil as the full size.

Kanger Mini T3s EgO Bottom Coil Clearomizer Tank System

ETA....They are about a half inch shorter than full size and hold 1.7ml.

 

[pufZeppelin]

I've looked around and can't find any real small tank/clearomizer with replaceable bottom coil. All the small ones I find are top coil or not coil replaceable. I got a Kanger T3S today thats 3ml, came with the bat and I don't like the length. I am wanting something around 1.5ml so the setup is shorter.

this is about the smallest set up I’ve run accross that is effective
- Kanger mini T3S clearomizer
- Ego C Batterie 1400mAh
- mini eGo 400mAh battery

 

[mmsjs5]

I have several of the mini T3S's. Love em and they use the same replaceable coil as the full size.

Kanger Mini T3s EgO Bottom Coil Clearomizer Tank System

ETA....They are about a half inch shorter than full size and hold 1.7ml.

litecig's last coupon code that I could find is ecf10

 

[atroph]

IMO Kanger EVOD clearomizers are pretty great for a little while in stock form. Then performance starts to degrade.

If you can do coils then you are golden as these coil units are fairly easy to recoil and wick.

I also widened my holes in all of my EVOD and T3S clearos to get a bigger draw at higher power without scorching the wick. In stock form I had to limit my power to keep from getting the coil too hot. I learned to loosen the coils up a bit and that helped spread the heat out vice using a tightly bunched up coil. Either way it still provided a mighty fine vape once I ditched the stock silica and went with organic cotton wicks. Best thing is that they are relatively inexpensive. I have 4 of them and 3 T3S and keep a constant flavor rotation going on throughout the day. Keeps me away from cigs which is all that matters to me in the end.

Now I am using rayon wick with more power, more vape, and more juice consumption (lol).

 

[charly1954]

this is about the smallest set up I’ve run accross that is effective
- Kanger mini T3S clearomizer
- Ego C Batterie 1400mAh
- mini eGo 400mAh battery

Tkd all for the input, appreciated.

I'm new to these bigger setups. I have vaped the thin e-cigs since Nov-2012, I got used to how small they was(4"-4.5"). I could put 2-3 in my pocket all with different flavors, thats why I want small tanks so I can fit at least 2 in my pocket.

The 1st setup I got about a week ago was a 650mah and w/tank it was 5", I like how short it was. Just bought a longer Kanger evod VV so I'm wanting 4-5 short tanks for it so its not so long. That Kanger ProTank 3 Atty looks like the size I want, found one on ebay and looks real short.

Kanger Protank 3 Atty Mini Aerotank 2 Coils Unitank Wicks Heads Evod T3S MT3 | eBay

Edited: Just read on the link the tank is 2.5ml, maybe longer than I thought. Probably pass on the Protank 3.

 

[charly1954]

The Kanger mini T3S clearomizer mentioned above looks like it is short enough and it says ego threads, which I new I had on both bats. But on the Kanger Protank 3 it said 510 threads so maybe it wouldn't work on my bats.

I thought 510 and ego was the same so I was going to ask if these would fit both my bats. Then I decided to one last time do more research on 510 and ego threads.
I couldn't understand why some bats/tanks said they fit ego but not 510 while others said fit 510 but not ego. I just found this link w/photo and I now understand that my 2 bats have both ego and 510 threads, so I think I understand. The 510 are the inside threads and ego outside.

http://newvape.blogspot.com.au/2013/07/will-someone-tell-me-difference-between.html#!/2013/07/will-someone-tell-me-difference-between.html

 

[pokemom]

Whoa!! If you are looking for tanks that are shorter that the T3S, the mini protanks or aerotanks will not solve your problem. Both are barely shorter than a T3S (maybe a millimeter). The evods (original) are shorter, about the height of a T3S mini.

This is a T3S and a Mini T3S side by side

Here is the T3S and a Kanger Mini Protank 3 side by side

Here is a T3S and an AnyVape Davide (the same size as a Mini Protank 2)

and here is the evod next to a T3S

Hope that helps, and good luck.


Sent from my iPad using Tapatalk

 

[charly1954]

Whoa!! If you are looking for tanks that are shorter that the T3S, the mini protanks or aerotanks will not solve your problem. Both are barely shorter than a T3S (maybe a millimeter). The evods (original) are shorter, about the height of a T3S mini.

Hope that helps, and good luck.


Sent from my iPad using Tapatalk

The Kanger VV 650mah and T3s I just got are 7" long. I knew it would be long but I wanted to try a VV battery. The AquaVapor 650mah Ce4 kit I bought to replace my V2's is 5" long, which is perfect, would like to get the Kanger VV down to at least 6".

The MT3S and evod look about 3/4" shorter than my T3S. If I can't find anything shorter I'll probably go with the MT3S. I don't mind having to refill so if I could find something that holds 1ml, that would be great. But I'd want replaceable coils and I've not seen any like that for 1ml. I imagine 1.6ml is as small as they go anywhere.

tks again everyone for the input.

 

[pokemom]

The MT3 is LONG, longer than the protanks!! It is just a T3S with a fancy cover. Your shortest options are the T3S mini or the evods


Sent from my iPhone using Tapatalk

 

[charly1954]

when searching for the mini T3S, its the same thing as the MT3S right?

They need a E-cig book for Dummies, there's to much knowledge to try to fit into a little brain.

Is there a list anywhere that list all clearmozers, sizes, and coil ohms.

edited: The Kanger site says MT3S are 70mm(2-3/4") so I guess its not that short compared to the T3S thats 3-1/8".

 

[pokemom]

No, it's not.

The tanks on order from left to right are MTS3, TS3, evod (original), and mini T3S

Hope that helps. The mini TS3 is harder to find, but I know litecig has it (that's where I got mine)


Sent from my iPhone using Tapatalk

 

[pokemom]

All of these tanks are from kanger. All are bcc. The MTS3, TS3 and mini TS3 all use the same coils. The evod uses the same coil as the protank & mini protank 2s (single coil). The protank 3 and mini protank 3 use dual coils which do not work in any of the tanks in the picture.


Sent from my iPhone using Tapatalk

 

[charly1954]

The Kranger says the Evod is 60mm, thats 2.36". This may be the best I can find. Its a replaciable bottom coil, short, and 1.6ml. One thing I don't like about it is it has a metal tank w/window. Would rather have a see-thru tank either pyrex or polypropylene.

 

[charly1954]

Tks for the photo pokemom. Maybe ur Evod original is longer than the ones now. Or its a missprint at Kanger site. Here's where I got the info from.

Kanger E-vod clearomizer – KangerTech

In ur photo the Mini t3s and evod look the same length. At Kangers site they say the Mini T3s(2-3/4") is longer than the Evod(2-1/3).

 

[pokemom]

Tks for the photo pokemom. Maybe ur Evod original is longer than the ones now. Or its a missprint at Kanger site. Here's where I got the info from.

Kanger E-vod clearomizer – KangerTech

In ur photo the Mini t3s and evod look the same length. At Kangers site they say the Mini T3s(2-3/4") is longer than the Evod(2-1/3).

I think they are only measuring the tank & not the base too.

The mini & the evods are really about the same size. If you like clear tank why not go with the mini? That said, I love my evods, and still go back to them a lot! They were my first "non-disposable" tanks.


Sent from my iPhone using Tapatalk

 

[pokemom]

You can find them here:

http://www.litecigusa.net/mobile/Product.aspx?id=41043

http://www.gotvapes.com/index.php?m...d=1476&zenid=9222d4cbaad5d23df814feba5ea5f30b

Both are forum suppliers so I hope it was okay to post the links.


Sent from my iPhone using Tapatalk