What a drag

Status
Not open for further replies.

minedbojo

Full Member
Jun 26, 2009
66
2
51
San Pedro, CA
Why is it that every youtube video I see from all these different people using all kinds of e-cigs; " taking these long deep drags"?
When I smoke analogs (Sorry still waiting for my first e-cig order; unfortunately its a blucig so I will still be smoking my analogs for a long....long.....time might get cancer before they arrive:lol:...lol.) I take much shorter drags. Is it me or am I missing something here?:confused:
 

Ehvam

Senior Member
ECF Veteran
Jun 21, 2009
208
57
New York, NY
It does take getting used to. Its my biggest complaint with vaping. When I first got it I was sucking on it so hard I thought I had popped a lung. (just reread that, yeesh, not good)
I tend to take very short mouth inhales with a analog then breath into my lungs, but with this its a bit different. But I hear it depends what model/type you get. I just ordered the 510 which, I hope, will let me take shorter drags.
 

NPerez

Full Member
Jun 9, 2009
63
5
36
Northern NJ
It does take getting used to. Its my biggest complaint with vaping. When I first got it I was sucking on it so hard I thought I had popped a lung. (just reread that, yeesh, not good)
I tend to take very short mouth inhales with a analog then breath into my lungs, but with this its a bit different. But I hear it depends what model/type you get. I just ordered the 510 which, I hope, will let me take shorter drags.
I have a 510. It's my first. What I get from a brief drag is probably similar to an analog..

But when you have a monster like a 510, you start to really want huge plumes of vapor, so I end up taking long pulls anyway:p

But I've never had to suck hard on it - usually that has a detrimental effect on vapor production, in my experiences
 

minedbojo

Full Member
Jun 26, 2009
66
2
51
San Pedro, CA
I have a 510. It's my first. What I get from a brief drag is probably similar to an analog..

But when you have a monster like a 510, you start to really want huge plumes of vapor, so I end up taking long pulls anyway:p

But I've never had to suck hard on it - usually that has a detrimental effect on vapor production, in my experiences

So longer softer drags; I wonder hows the throat hit when doing that?
 

minedbojo

Full Member
Jun 26, 2009
66
2
51
San Pedro, CA
It depends on what device they're using too. The more voltage, the shorter the draw.

I did not know that the units had diff. votages; I thought there would be a sort of a standard for these things. But then higher voltages would create heating issues right? That would explain the cut off times on these auto units versus the button activated ones. 8-o Hugh just had a brain fart sorry...:oops:
 

CardinalWinds

Super Member
ECF Veteran
Verified Member
May 25, 2009
495
314
Vermont, USA
I did not know that the units had diff. votages; I thought there would be a sort of a standard for these things. But then higher voltages would create heating issues right? That would explain the cut off times on these auto units versus the button activated ones. 8-o Hugh just had a brain fart sorry...:oops:

I could never go with an automatic battery since having a manual switch on my 510. No cut off on manual batteries. Total control over your draw.

Most all e-cigs operate at 3.7 volts, the exceptions being the mods like the Prodigy and the SD. They run a bit higher, in the 5 to 6 volt range, and consequently produce more vapor more quickly.

Compared to analogs, a slower longer draw is the key...at least for me. I take draws off of my 510 that would leave me hacking on an analog. Keep in mind too, that it has been tentatively shown that nicotine absorption with e-cigs is done more through the mucous membranes in the mouth than the lungs, so let it roll around in your mouth a bit before inhaling and enjoy the superior taste. :)
 

nitewriter

Ultra Member
ECF Veteran
Jan 2, 2009
1,226
28
Hendersonville Tennessee
I did not know that the units had diff. votages; I thought there would be a sort of a standard for these things. But then higher voltages would create heating issues right? That would explain the cut off times on these auto units versus the button activated ones. 8-o Hugh just had a brain fart sorry...:oops:

I was talking more about devices like the Prodigy, Light Vaper, Screwdriver, etc. There's a huge difference from traditional e-cigs to mods in voltage and in draw.
 

Michele

Super Member
ECF Veteran
Jul 1, 2009
570
56
60
Lewisville, Texas
I could never go with an automatic battery since having a manual switch on my 510. No cut off on manual batteries. Total control over your draw.

Most all e-cigs operate at 3.7 volts, the exceptions being the mods like the Prodigy and the SD. They run a bit higher, in the 5 to 6 volt range, and consequently produce more vapor more quickly.

Compared to analogs, a slower longer draw is the key...at least for me. I take draws off of my 510 that would leave me hacking on an analog. Keep in mind too, that it has been tentatively shown that nicotine absorption with e-cigs is done more through the mucous membranes in the mouth than the lungs, so let it roll around in your mouth a bit before inhaling and enjoy the superior taste. :)

That's good for me to know. I'm still waiting on my first e-cig as well (510) and I draw on the analog moderately, but I tend to hold it in my mouth a few seconds before blowing out the smoke. (maybe an old habit from my younger years?) Anyway, I smoke ultra lights and have wondered if the 510 will be a bit harsh of a throat hit for me. I went with 10mg nicotine to start. I guess I'll find out soon. :thumb:
 

Applejackson

Super Member
ECF Veteran
Jun 30, 2009
989
13
Albany, NY
I've seen a few posters mention adding glycerine to their e-juice to produce more vapor and would like to know where to get some so I can try it for myself.

You can find small bottles of glycerin at Walmart (I only found small bottles anyway, just make sure it's pure glycerin USP--the bottle calls it a "skin protectant"), or you can find it many places online. Just google and shop for good prices.:thumb:
 

Applejackson

Super Member
ECF Veteran
Jun 30, 2009
989
13
Albany, NY
That's good for me to know. I'm still waiting on my first e-cig as well (510) and I draw on the analog moderately, but I tend to hold it in my mouth a few seconds before blowing out the smoke. (maybe an old habit from my younger years?) Anyway, I smoke ultra lights and have wondered if the 510 will be a bit harsh of a throat hit for me. I went with 10mg nicotine to start. I guess I'll find out soon. :thumb:

I don't think the throat hit will be a problem at 10mg. You can always take smaller drags too, but I think you'll find the "throat hit" is not as harsh as you're thinking it will be. After all, it's not smoke ;)
 

DC2

Tootie Puffer
ECF Veteran
Verified Member
Jun 21, 2009
24,161
40,974
San Diego
Why is it that every youtube video I see from all these different people using all kinds of e-cigs; " taking these long deep drags"?
When I smoke analogs (Sorry still waiting for my first e-cig order; unfortunately its a blucig so I will still be smoking my analogs for a long....long.....time might get cancer before they arrive:lol:...lol.) I take much shorter drags. Is it me or am I missing something here?:confused:
Every video review I have seen, those people are taking longer drags than I normally do. I am guessing that they are trying to maximize vapor production for demonstration purposes. But having said that, yes, with most models of electronic cigarette you do have to take a longer draw that a normal cigarette.

With models that have an automatic battery you REALLY have to take slower drags, which generally means even longer drags. You have to draw hard enough to activate the battery but not too hard or it will activate the battery cutoff way before you want it to, at least for me.

One of the problems is there is much less airflow, in general, than a normal cigarette, so the draw is also generally harder, which is also a factor in the need for longer draws. People do various modifications to resolve some of these issues.

As an example, I have taken my RN4081 (NPro) and removed the cartridge from inside the mouthpiece, and then I bore out the little hole in the bottom of the mouthpiece with a screwdriver until it is nice and big. My airflow is increased significantly, and so my draw is much easier. Of course, since I have no cartridge in there anymore, I can only use it for dripping, which is something it is pretty good for anyway.
 
Status
Not open for further replies.

Users who are viewing this thread