What improvements would you like in the Fogger V2/V3?

[bulldog63h]

My SVD will not fire anything under 1.3 ohms.

 

[whyzer]

Check out "reviews by Todd" on youtube.He does an extensive review and from what I've seen the contact pin may be potentially hazardous.

 

[Fullknight]

Wait, it works on the evic but the ohms are too low for the SVD? That doesn't sound right.

I've got an evic, one of my son's has another evic and the other son has the iTaste SVD. Our evic's will fire to around 1.1 ohms, any lower and it won't work, won't fire. I think it says atomizer short.

The iTaste SVD HOWEVER will fire SUB OHM... 0.9 ohm anyway for 100% certain. He does it!

Honestly the SVD seems a little more forgiving than the evic.

Double check that. If it fires on your evic I guarantee you it should fire on the SVD. Check the center pin on your SVD and see if it might be too low to make contact with the 510 center pin of your Fogger.

Sent using my typewriter

It will fire on a mech mod with a sigelei kick,smok kick, and I'm pretty sure I got to fire on my MVP.

Edit: I tried,it will fire on my MVP and it shows 1.1ohm.

 

[Jazzi Mike]

I would turn it into a Reo and reomizer combo.

 

[Phone Guy]

Very strange. The one and only SVD I've had access to does fire coils as low as 0.9 ohm. Guarantee. But I guess there are all a little different? What can I say?

Sent using my typewriter

 

[scrappy]

If you have wandering ohms it's usually from poor contact between the wire and mounting screw. Tighten it up and see if it helps. You should have a good idea what your resistance is by how many wraps of wire and the size it is. For example, 8 wraps of 28g on a 16g needle should be .8 ohms.

Also, the suggestion earlier of putting the o-ring on the 510 pin is a good one even if it's for peace of mind.