I'm not sure of the air path.. I'm asking because I recently had a brand new boge from an old/good pack, and the draw is just incredibly tight.
it works fine, but the draw is exactly the opposite of most boge's.. CRAZY tight.
I've kind of adjusted the air hole down through the middle, it was kind of crooked, I can now totally see through it.
I'm using it on a SS Vtube w/ a tank. I've gone through maybe a dozen different cartos in the last month, with no issues what so ever short of just wearing the darn things out and swapping them out to change flavors.
All of my liquid is 50/50.
Thanks
Edit:
I fixed it! Ended up using a .050 hex driver to make the center hole bigger.
I carefully pushed the driver all the way through the hole, then just slowly pushed around in all directions. It was just a little bit too narrow near where I punched a hole.
Does an edit count toward my newbie post restrictions?
it works fine, but the draw is exactly the opposite of most boge's.. CRAZY tight.
I've kind of adjusted the air hole down through the middle, it was kind of crooked, I can now totally see through it.
I'm using it on a SS Vtube w/ a tank. I've gone through maybe a dozen different cartos in the last month, with no issues what so ever short of just wearing the darn things out and swapping them out to change flavors.
All of my liquid is 50/50.
Thanks
Edit:
I fixed it! Ended up using a .050 hex driver to make the center hole bigger.
I carefully pushed the driver all the way through the hole, then just slowly pushed around in all directions. It was just a little bit too narrow near where I punched a hole.
Does an edit count toward my newbie post restrictions?
Last edited: