What "ohms" Fluxomizer to get?

[CaliVaper]

Hi, I've decided to try out the fluxomizer supremes. KR808 REGULAR sized, my question is what strength (OHM) should I get? 2 of my batteries (1 auto/1 manual) are from V2 cigs...4.2V UNregulated. I also use a SmokelessImage VOLT sealed auto battery... 3.6V regulated.

As for juices... I vape anything from darker/thicker juices like chocolate to clearer/thinner juices. Usually whatever I get is either straight PG or in the area of 70/30 (pg/vg). So in order to avoid burning out the coil and/or burning the juice... Would I be better off with the 2.4-2.6ohm or the 2.8-3.0ohm version???

 

[Briar]

Don't want you to feel ignored, but sorta don't know what to tell ya... I'd use the 2.6 - 2.8 range - to me they are the most flexible - but they don't seem to be around anymore.

If it was me, I'd get the higher Ohm range, because I absolutely *hate* fiddling with wicking issues - but I'm not a very good fiddler, and so I always go for the safest choice. I am not into hotter vape either, I like it warm, but not hot.

If the latest Fluxo version is more or less the same as the previous one, wicking-wise, you shouldn't have any problems with the regular size though - you might have to widen the wick slots slightly on the heavier juices, but maybe not. On the old ones all I did was the "doughnut" mod and it wicked anything empty. But the lower Ohm range was just too hot for me, so I only tried it once.