What voltage or wattage should I be using?

Status
Not open for further replies.

Ctip

Full Member
Sep 5, 2014
19
2
Kennesaw, GA, USA
I have a itaste mvp with aspire nautilus large tank. Ive had it anywhere from 3.8 to 4.5. I had to buy new coils the other day and the guy told me i should be around 4.5-4.9, i put in a new coil and less than 24 hours I had that burnt taste and very little smoke. I replace the coil and lowered it to 4.2 and it seems fine for the last 48 hours.

Just wondering where it should be. I had the iclear 30 at about 3.8 and it would last 1.5 to 2 weeks before i had to replace coils, with the nautilus i am only getting a week max before replacing. Same with my kanger tank but less than a week.

Thanks for the help.
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
I have a itaste mvp with aspire nautilus large tank. Ive had it anywhere from 3.8 to 4.5. I had to buy new coils the other day and the guy told me i should be around 4.5-4.9, i put in a new coil and less than 24 hours I had that burnt taste and very little smoke. I replace the coil and lowered it to 4.2 and it seems fine for the last 48 hours.

Just wondering where it should be. I had the iclear 30 at about 3.8 and it would last 1.5 to 2 weeks before i had to replace coils, with the nautilus i am only getting a week max before replacing. Same with my kanger tank but less than a week.

Thanks for the help.

The higher the power level you run at the shorter your coils will last because you'd be vaporizing more liquid.

A week is a long time to run on one coil (for me). I used to run single coil protanks for about 3 days.
 

Jdurand

Ultra Member
ECF Veteran
Verified Member
Oct 16, 2014
1,802
2,201
Long Island, NY
On a new coil you should set the MVP at about 3.5 volts and then after 20 - 30 puffs start to increase till you find the spot you like. Coils, when new, need to be primed with a few drops of juice and allowed to sit for ten minutes or so after you fill the tank. Coils usually last me 45 - 60 ml of juice each (3-4 days). If you don't prime and use a low voltage break in on nautilus coils, they burn out fast.
 

Ctip

Full Member
Sep 5, 2014
19
2
Kennesaw, GA, USA
On a new coil you should set the MVP at about 3.5 volts and then after 20 - 30 puffs start to increase till you find the spot you like. Coils, when new, need to be primed with a few drops of juice and allowed to sit for ten minutes or so after you fill the tank. Coils usually last me 45 - 60 ml of juice each (3-4 days). If you don't prime and use a low voltage break in on nautilus coils, they burn out fast.

Thanks very helpful and informative advice. I usually let is soak with a new coil for 3-5 minutes before using. I think that may have been the problem with the new coil starting at 4.5 immediately after 3 minute soak.
 

Ctip

Full Member
Sep 5, 2014
19
2
Kennesaw, GA, USA
There is no right or best V or W settings.
Pick one or the other (V or W) start off at a low setting and work your way up taking a vape or three on each setting until you find what you like, if you get a burnt taste turn it down a little.

would the burnt taste just be a destroyed coil? too late?
 

WTracyS

Full Member
Nov 5, 2014
20
4
Vail, AZ, USA
I had a similar problem with the Nautilus. So much I liked about it, but so many frustrations. Being a little *nal retentive, I took to keeping a log of what kind of juice, my setting, how long the coil lasted, and whether the bad taste was mild or foul. Then I started experimenting on the coils themselves. I went through about 10 coils before I thought I had it down. In other words, I could consistently keep a coil alive for more than a day or two. Here's the tricks I figured out

A burnt coil is a dry coil. You gotta keep that bugger wet.

When you first take the coil out of the package, put a couple of drops of juice right on the coil. Screw it into the base, set the base on the collar to hold it up, and go get a cup of coffee or something. When you come back in 5-10 minutes, put another couple of drops of juice right on those coils. Fill the tank and put it together (make sure and screw it down really tight). Now put the tank down on the collar and go find something else to do for 5-10 min.
Close down your air flow to the half way mark, and vape on low volts/watts a few times nice and slow. Don't suck on it like a straw, or you'll flood the thing and have to clean it up before you can move on.
Now you can open up your airflow, turn up the power, and vape to your little heart's content.

Couple of side notes....the Nautilus is easy to flood. Make sure you're pulling slow and easy. You can open up the corner of your mouth a little too to control the suction. If you do flood it, take off the tank, remove the coil, and wipe it all out completely (make sure to get under the drip tip too). Put it back together, and dry fire your coil in a couple of quick bursts. Then you should be good. If it's flooding, you're sucking too hard.

Also, when you set it down, set it down upright. For a few minutes is no big deal, but leaving it on it's side seems to make it a little more prone to flooding.

On the opposite side, if you set it down for a long time, the wick can dry out a little, and you could get a dry hit, or worse, a burn out. So, in the morning, after it's set all night, turn down your air flow, and give it a couple pulls without firing. Or you could open it and put a couple of drops on the coil, but that might flood it. You just need a little juice once the coil is wet. After a couple of pulls without heat, you can go back to your regular setting, and should be good.

These coils should last 1-3 weeks depending on your settings, and how much you vape.

Kind of a pain in the posterior, but totally worth it for the excellent vape off of pre packaged coils
 

Ctip

Full Member
Sep 5, 2014
19
2
Kennesaw, GA, USA
I had a similar problem with the Nautilus. So much I liked about it, but so many frustrations. Being a little *nal retentive, I took to keeping a log of what kind of juice, my setting, how long the coil lasted, and whether the bad taste was mild or foul. Then I started experimenting on the coils themselves. I went through about 10 coils before I thought I had it down. In other words, I could consistently keep a coil alive for more than a day or two. Here's the tricks I figured out

A burnt coil is a dry coil. You gotta keep that bugger wet.

When you first take the coil out of the package, put a couple of drops of juice right on the coil. Screw it into the base, set the base on the collar to hold it up, and go get a cup of coffee or something. When you come back in 5-10 minutes, put another couple of drops of juice right on those coils. Fill the tank and put it together (make sure and screw it down really tight). Now put the tank down on the collar and go find something else to do for 5-10 min.
Close down your air flow to the half way mark, and vape on low volts/watts a few times nice and slow. Don't suck on it like a straw, or you'll flood the thing and have to clean it up before you can move on.
Now you can open up your airflow, turn up the power, and vape to your little heart's content.

Couple of side notes....the Nautilus is easy to flood. Make sure you're pulling slow and easy. You can open up the corner of your mouth a little too to control the suction. If you do flood it, take off the tank, remove the coil, and wipe it all out completely (make sure to get under the drip tip too). Put it back together, and dry fire your coil in a couple of quick bursts. Then you should be good. If it's flooding, you're sucking too hard.

Also, when you set it down, set it down upright. For a few minutes is no big deal, but leaving it on it's side seems to make it a little more prone to flooding.

On the opposite side, if you set it down for a long time, the wick can dry out a little, and you could get a dry hit, or worse, a burn out. So, in the morning, after it's set all night, turn down your air flow, and give it a couple pulls without firing. Or you could open it and put a couple of drops on the coil, but that might flood it. You just need a little juice once the coil is wet. After a couple of pulls without heat, you can go back to your regular setting, and should be good.

These coils should last 1-3 weeks depending on your settings, and how much you vape.

Kind of a pain in the posterior, but totally worth it for the excellent vape off of pre packaged coils

Thank you for doing all the trials and error. I will follow your advice the next time i need to replace a coil. Again thanks alot for the informative response,
 

Evaravenspell

Senior Member
ECF Veteran
Verified Member
Apr 15, 2013
220
248
KL, Malaysia
Use one of them calculators and tell it the resistance of your tank/dripper. It will tell you what v/wattage you should vape at. But then again all these are based on personal preference. I sometimes like it warm and sometimes like it hot. Usually i get the recommended wattage and play around there.
 
Status
Not open for further replies.

Users who are viewing this thread