Where can I get a PV with an sx350 chip

[flexsr]

Hey all,

After wasting money time and effort lol I found that for me personally the better vape is something at .6-1.2 ohms at 2.5ish -3.9ish Volts.

Someone mentioned the sx350 chip as a good chip for what I was looking for. Is this something I have to get custom or are there PVs in mass with this chip ? If so what are some devices I can check out and which would be your favorite?

I bought a Cana -30 without doing my homework and I absolutely can not find an enjoyable vape with it. The minimum voltage is 4 volts and the problem I run into is at the higher ohm builds I get no flavor or vapor and at the lower ohm builds I always get a burnt taste. (This is with an rta. rda would rectify the burnt taste but I just don't find them practical for me) .

Any input would be greatly appreciated

 

[Aal_]

I would like to know this as well. Sx350 is way better than dna

 

[flexsr]

Someone help please ?

 

[Butt Kickers]

I'm interested as well

 

[Aal_]

Guys visit pimodz.com I just picked up one.

 

[Andrew H]

The main PCB suppliers located in ShenZhen are available on alibaba, despite the horrible stories it is still profitable to buy chips directly from them. For experienced ones, just search anything you want, like "APV DIYer PCB", or custom box mod or vamo chip, and you will find something.

 

[CMD-Ky]

Tatroe Atlas and BCModz, both are pricy but well built. The Atlas is an 18650 and the BC is a 26650. The SX-350 will go as low as 5.0 Watts and, depending on the status of the board flash as high as 50 Watts with plans to go higher. You might also give consideration to Provari, it seems to have a bit of a following here.

 

[Whistle_Pig]

Pioneer4u IPV v2 50 Watt. Check with GotVapes on their subforum here to be sure -- they list the 30W version as using the SX330, I assume this uses the SX350.