Where to buy parts

[HokieSmokie]

Imeo. I have the GGT .. I think that was the name, NOT the 'transformer' but the one previous. I think I need to purchase a new top piece. The part where the atty screws in because that little pin that connects to the atty when screwed on sometimes, no, OFTEN sticks and I have to unscrew the top, and push it up manually so it makes contact.. Do you have any of those tops ?? I am pretty sure they are NOT the same fit as the GGTS. Once you offered to fix it if I send it to you .. THANK YOU MUCH .. but I hate to be without it for so long - even though I have other PVs .. this is BY FAR my favorite.

Diane

 

[imeothanasis]

Diane, if you send it to me I will fix it. I know what you mean when you say that you dont want to loose it but for older GGs I have to have them here. Sorry dear

 

[HokieSmokie]

would you need me to send the whole thing ?? Or just the top piece .. PM me your address and I will see if I can pry it out of my hand .. OR .. Can I buy another top ??

 

[Stormynights]

I think you might just need to put a little Vaseline on it. You just need it to slide easier?

 

[imeothanasis]

You just need a new connector Hokie. Send me only the cap and I will make a new connector for you. Or maybe we can do something else. Unscrew the connector and meassure it. I want you to tell me the total height of the brass connector and the width of its polygonal base and I will make a new one to send you. I need only 7 euros postage from you.

 

[HokieSmokie]

I will FOR SURE give that a try .. maybe later tonight and report back to you. This is my eBay [jewelry] listing day ...

 

[imeothanasis]

I will wait Hokie

 

[HokieSmokie]

Before I start ... When you say "unscrew" do you mean to remove the washer from the underside of the cap and then measure?

 

[imeothanasis]

The atomizer's cap of GGT is aluminium. The connector is brass. Unscrew the brass connector from the aluminium cap and meassure it.