which one to get

[rob87]

hello all,
first off i am a complete noob at this and what to start using a rda or rba(not sure even which one).
I am using a altsmoke bb aw ic batts( if that matters).
I am looking for something that would fit nicely on that and very easy to start with.can someone recommend a dripping atomizer to use and what kind of equipment i will need to start with.again anything or any kind of advice would be helpful...thanks in advance

 

[ukeman]

aloha bro....
i have a bb too; one of my first mods... don't use it much anymore but its a kind of a classic!
i don't think its fully mechanical so you don't want to use SLR... super low resistance; in fact newbs shouldnt go there right off the batt (pun intended).
It goes off the power of the batt without boost so you need to go with LR.

For RDA, you could do worse than an iGo L... or a 2 post dripper. (if you go 3 posts that means dual coils and that will get you into SLR territory. it can be dangerous)

Coil building for iGoL with a bb:
32g is easier to use and will give a higher resistance than 30g, so i say do a 4 or 4/5 wrap to be safe.
4 wraps means the tails of the wire will be on different sided of the wick when done... and this is cool for rda's. You position the wick/coil in between the posts..... 4/5 has the tails on the same side of the wick....and you position it on the side of the posts... before you tie into the posts....either way works.

I'd shoot for about 1.4 to 1.5 ohms; as far as i know the bb should be fine with that...
***better yet, get an ohm reader and meter the resistance to be sure.... Madvapes has a good one.