Words if advice before pulling trigger on DIY

[Heabob]

I just put a 1.8 ohm coil in one of my kayfuns and get very little TH and flavor. I am running a mech mod though so that may make a difference. Debating on making a mod that I can use 2 18650 bats in and start at 2ish ohms to see the difference there.

Maybe you should try some stronger type flavors...

I can only use these at 5% or less.

Pineapple TPA
Pina Colada
Tiramisu FA
Horchata Base TPA
WG Orange Inawera (don't have it yet, but read it's real strong)
Cinnamon Roll FW
or
Cinnamon Danish Swirl
Parliament VZ (Kind-of tobacco-ish) unique flavor tho. (3% is strong)

Add some creams/vanillas with those:
Vanilla Swirl TPA
Vienna Cream FA
Vanilla Custard CAP
NY Cheesecake CAP
Cookie CAP

You can add some TH with a few drops of PGA (pure grain alcohol).
Or raise up your nic to 18mg.
Higher PG mixes, ie 80/20 will increase TH.
I choke on 6mg, as I now use 2mg and some 0mg.

Be careful of some of these flavors and Plastic tanks.

 

[RocketPuppy]

INDEX CARDS!!! On the blank side, write down your mix when you first make it. Each time you adjust it to flavor, jot down the changes. Once it is perfect for your taste, flip the card over and scribe your permanent recipe. And of course share with us! It sucks to finally make the perfect blend, and then realize that you have no idea how you got to it!

As a side note, you will have mixes that you find are simply not good. Dont throw them away. Mix them with other bad mixes in the future and you may get some good random tastes! lol

Worse comes to worse, you can make homemade a pesticide.

Great idea about the index cards. Thank you.

 

[RocketPuppy]

Listen to doots. Same advice I'd give.