worried noob vapors

[eggertklowski]

Hi vapors. im eggert. Im a noob n new in this vaping world. I have read a lot about it n still not quite sure bout it. My questions are: 1: is it safe to vape on my mod which im using 50w mini flask mod. Im not sure if it regulated mod or not, with samsung battery inr 18650 25r 3.7v 2500mah li ion rechargeable. Also using kanger tech sub mini tank with 0.5 sub ohm which fluctuates a bit 0.4 and currently sits at 0.38. 2: why it jump? Is it screw loose issue? Im still on the pre made coil from kanger btw. I have tighten the screw and loosen up my wick as tutorial from utube. Haha maybe im wrong cos im really not quite sure a bit. Pls do help me on this n 3rd question if i increase my watt is it ok as long i dont go beyond my battery voltage of 3.7v?. Im really worried if i do it wrong way n my mod will be a time bomb like i read some article..advance thks n happy vapping. Cheers ps; english is not my language pardon me if it bad.

 

[Sir2fyablyNutz]

hi @eggertklowski and welcome to the forum. I am not familiar with your mod but the batteries you chose are a good quality. I would highly suggest a separate battery charger to recharge the batteries rather than a USB port in the mod if it has one. Nitecore and Xtar are the most popular.

Factory mass produced coils can be off by a tenth (.10) or so, as well as the mods reading of a coil. Small fluctuations are not much to be concerned about. I vape my .5 ohm Kanger coils around 20 to 25 watts with no issue.

The rule of thumb with any vape device is to start low power, take a draw, bump it up and repeat. If it tastes funny, is too warm, or starts to taste burnt back it down.

Good luck in your journey.

 

[edyle]

Hi vapors. im eggert. Im a noob n new in this vaping world. I have read a lot about it n still not quite sure bout it. My questions are: 1: is it safe to vape on my mod which im using 50w mini flask mod. Im not sure if it regulated mod or not, with samsung battery inr 18650 25r 3.7v 2500mah li ion rechargeable. Also using kanger tech sub mini tank with 0.5 sub ohm which fluctuates a bit 0.4 and currently sits at 0.38. 2: why it jump? Is it screw loose issue? Im still on the pre made coil from kanger btw. I have tighten the screw and loosen up my wick as tutorial from utube. Haha maybe im wrong cos im really not quite sure a bit. Pls do help me on this n 3rd question if i increase my watt is it ok as long i dont go beyond my battery voltage of 3.7v?. Im really worried if i do it wrong way n my mod will be a time bomb like i read some article..advance thks n happy vapping. Cheers ps; english is not my language pardon me if it bad.

1: No it is not safe, but like driving a car, as long as you pay attention everything should be fine.
If it says 50w, then it's a regulated mod.
2: Why it jump: contact points.
3: If you increase watts gradually, at some point you will notice it starts to taste a little burnt, at that point you decrease watts.

 

[Baditude]

Make sure that your post screws are snug on your RDA. Loose post screws can change the coil resistance by as much as 0.5 ohm....from personal experience.

 

[eggertklowski]

Thk you so much guys. Appreciates it a lot in a short period replies. Once again ty n happy vaping..