xvostick clone any owners?
- Thread starter SLvapor
- Start date
- th_trl_thread_readers 0
- Status
When you say relock, what exactly are you talking about? A couple of times over the 8 days, it has asked me it this is a new coil. Is that the relock? I have not had any since we started this conversation.
Definitely not happening to me. Mine was on the last bar when we started this and I have sucking on this thing non stop to try to kill it. No messages and still not dead. Has been over 40 minutes.
Altho not even close to being any sort of an expert, I'd be happy to chime in on the DNA40. Both DPL and I have the authentics. mgm, if you could pose specific questions, we might be able to add some info here.
I can tell you (just from what you've said and asked) that mine has not asked for the "new coil?" at all, unless I've changed toppers in it. Batt life doesn't seem to provoke that.
Could be my battery indicator is faulty?? Think it would have died by now. I chain vape all the time and this is killing me! I normally run in stealth mode to save on battery so don't watch it go down. Still gives me any messages. I will watch it tomorrow.
Other than when I change attys, I have only had that message a few times. Definitely a glitch in the chip. No idea what causes it. I have only been running the 30Q batteries.
When my battery has been at 1/4 for a while (maybe an hour) If I don't change battery I will get message " new coil up same down "
The longer I run mod with battery low the more frequent the message. Not a biggie I just switch to a new battery. Getting an avg of 8 hours vape time in power mode with a .8 ohm coil at 35 watts with efest 35 amp 2500 mah battery
The longer I run mod with battery low the more frequent the message. Not a biggie I just switch to a new battery. Getting an avg of 8 hours vape time in power mode with a .8 ohm coil at 35 watts with efest 35 amp 2500 mah battery
I've had over 10 DNA 40 mods and the last 4-5 have had zero quirks. The last revision or two have been money.
Hmm maybe I need to retract what I just said about needing to relock atty at about 1/4 battery life....
Found a battery issue. One mod would only work in upright postion. If I tipped upside down battery would lose contact. Put another battery in and it works in any postion. Seems as though I am tighting down to tight and indenting the positive end of battery.
Can I lift up the positive tab on a battery without shorting it out?
Found a battery issue. One mod would only work in upright postion. If I tipped upside down battery would lose contact. Put another battery in and it works in any postion. Seems as though I am tighting down to tight and indenting the positive end of battery.
Can I lift up the positive tab on a battery without shorting it out?
Ditto but only 4!
I believe we are referring in our case to a authentic Evolv chip and not this clone chip in the clone stick. Matter of fact, just a few days ago, I accidently ran my authentic down to "zero/empty icon" which had a VCT 5 in it. Still gave me a shorter pull (which is how I noticed) and also flashed on the screen to me...gramps! It's time to swap your bat. Do it! Or I'm going to stop working!
I presume you can still keep vaping with these little glitches ? so when I get my clone I won't look at the screen. /lol
Last edited:
Let me retest this again today........ Now I think it was a battery issue being just a tiny bit short. I have ran this present battery real low without any issue. Just tested that battery it's at 3.5 volts
Shortly after I logged off yesterday, my battery indicator went to zero bars and I started getting a low battery message when I tried to fire mine. So everything looks good on mine. Sounds like you found your issue with the battery.
You get a "Ohms Too High" error message when in the power mode and using a coil over 1.0 ohms resistance.
What do you have the watts set at when you get this error message?
Have you tried lowering the watts to see if you still get this error message when using a coil of greater than 1.0 ohms resistance?
From reading some of these posts here, it seems like some of you have had issues getting the XvoStick clone from 3FVape within a reasonable amount of time ... Has any of you tried ordering this clone from FocalEcig ?
About the same price as 3FVape.
http://focalecig.com/Product/Xvo-Stick-Style-40W-TC-Variable-Wattage-VW-APV-Box-ModBlack-30181
About the same price as 3FVape.
http://focalecig.com/Product/Xvo-Stick-Style-40W-TC-Variable-Wattage-VW-APV-Box-ModBlack-30181
- Status
