ZENITH COILS

[Uncle]

Lat me page someone who uses the 1.2Ω coils and likes them a lot: @hittman and @Uncle your input is kindly requested.

Well- Okay, glad I was rooming around and saw this thread, since I never got your "Tag" . . . Anyway, Hopefully I can be a little helpful given the original question . . .

Hello,
I would like to ask if anyone had problems with 1,2 zenith coils? Do they last? Or they burn very quickly?
Every opinion will be really appreciated
Thank you

1) I have had - No problems at all using the 1.2 oHm Z-Coils - nor the 1.6 oHm coils either . . .
Only had one Z-Coil that was DOA from the get go, which is not really uncommon for any pre-made coil.

2) Oh Boy - Do they last . . . However, not everyone has the same experience as I do, especially since I use Unflavored 24 NIC 50/50 E-liquid with Koolada and 1-3 drops of Menthol Crystal Liquid . . .

Further more, about coil longevity - which leads me to repeat what I posted in another thread when some one was concerned about what oHm Z-Coil to use . . . "it all depends on your vaping habits and what kind of e-liquid you vape."

Personally, [I use] - both 1.2 oHm & 1.6 oHM [Z-Coils] coils . . . On average, I use a single coil anywhere from 60 - 90 + days before I would have to change it out. (And then usually it was only because I let the e-liquid get to low and the coil was "burnt". . . Could possibly be what costumer is doing to get a "Burnt" taste ? )

BTW: Just remember, depending on the e-liquid you use, Z-Coils can easily be cleaned and reused.​

Hope that this information is somewhat helpful . . .

If I can be of any other help or you have anymore questions - I'll do my best to answer them. . . .


.

 

[rosesense]

I use mostly the .8 coils as that is my preference. The only time I got close to burnt taste was when the wattage was accidentally turned up too high or eliquid was too low.

 

[Uncle]

@Vasiliki Sugar . . .

BTW: What Innokin Tank/POD and type of MOD is your customer using? What wattage or volts is the MOD set at? Also what kind of E-liquid, PG/VG, Flavor - is it a strong/dark/thick Flavor? All of these can be factors to consider . . . Just Sayin' . . .


.


.

 

[Vasiliki Sugar]

@Vasiliki Sugar . . .

BTW: What Innokin Tank/POD and type of MOD is your customer using? What wattage or volts is the MOD set at? Also what kind of E-liquid, PG/VG, Flavor - is it a strong/dark/thick Flavor? All of these can be factors to consider . . . Just Sayin' . . .


.


.

we've already seen these factors. She is using zlide tank. usually 12 watts. 50/50 PG/VG with strong flavour but not dark. thank you very much for your response too.

 

[Superuser187]

If u still have problems with the customer just tell her that even if flavour get muted after a while at least tastes better than a cigarette
Cause I think the problem is flavour and not any bad burned taste sooo it's fine

 

[Uncle Willie]

I use mostly 70% PG eliquids and never had any problems with any of the Z coils. But they do need to be primed well. Once they are thoroughly primed and broken-in, they are wonderful.

Yes .. 1.6 here, 70PG / 30VG, menthol only, very clear liquid .. lasts an average of 30 days ..

Great stuff ..