What Mesh and Kanthal for an AGA t2?

Discussion in 'General Vaping Discussion' started by gezichtmitnase, Dec 4, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. gezichtmitnase

    gezichtmitnase Full Member

    Joined:
    Oct 9, 2013
    Location:
    Netherlands
    hi guys.

    im about to buy an AGA t2, and i want to get some spare mesh and kanthal with it.
    but what kind of mesh works best with it? and what kind of kanthal?
    Mesh options are : 325, 400, 500
    kanthal: 'ribbon' 0.15, 0.18, 0.20 and 0.26

    Im a newb, but i'm ready for a better vaping experience and hoping it can turn into a hobby. im pretty handy so rebuilding shouldn't be that much of a deal.

    using a SMOK SID.

    THANKS for the help guys.
     
  2. gezichtmitnase

    gezichtmitnase Full Member

    Joined:
    Oct 9, 2013
    Location:
    Netherlands
    bump bumppp
     
  3. Sthur

    Sthur Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 14, 2013
    Location:
    Denver
  4. Vaslovik

    Vaslovik Ultra Member ECF Veteran

    Joined:
    Jul 5, 2013
    Location:
    Cape Coma Florida, USA
    What kind of mod are you using it on? The AGA-T2 was my first RBA, and I've always used mechs, so I went with 400 mesh and 28 kanthal, 4/3 wrap for .8 ohm, which continues to serve me very well. If you are using a regulated mod try 30 kanthal.
     
  5. K_Tech

    K_Tech Slightly mad but harmless Verified Member ECF Veteran

    Supporting member
    Joined:
    Sep 11, 2013
    Location:
    Eastern Ohio, USA
    What juice are you going to be running in it? Conventional wisdom seems to point towards lower mesh numbers for thicker juices (higher VG content) and higher mesh numbers for thinner juices.

    I don't have a T2, but in my other Genny attys, I have been using both 400 and 500 mesh and I vape 50/50 almost exclusively. I've noticed a tiny bit of difference between the two, but nothing that I can't attribute to my coil building skills (or lack thereof).
     
Thread Status:
Not open for further replies.

Share This Page