◙ Li’l PINCH (←thang) ◙ pdib (←maker) ◙ not sayin’ (←just sayin’) ◙ shuh-ZAM! (←hyperbole)
- Thread starter pdib
- Start date
- th_trl_thread_readers 0
- Status
They should have an episode of "How Do They Do it" on Discovery for these! No kidding!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Good lord.....nice job!
Wowzers. Can't wait to get mah mitts on that. Goes without saying, well done on this batch Peter!
Yeah good thinking, the Chinese (and the Kiwis) will be glued to the screen watching those episodes
Yeah good thinking, the Chinese (and the Kiwis) will be glued to the screen watching those episodes
If that was the case then all those who appeared on this program are currently out of business [emoji848][emoji57]
Sent from my iPhone using Tapatalk
Aaa Haa, now I know why the "Blue Maker"
Kinda matches your "work truck" pretty well doesn't it
Super nice choice of wood block you did there Catfish
Looking at your cap fitted and the height of your coils, I coulda made it even a bit shorter in fact. Hope you like it Pete
Hey I can always make a shortie for ya if you want
Hey I can always make a shortie for ya if you want
no sir. so far it seems just right! very nicely done too, i might add. nice snug fit on the o-rings, feels good on the ol' kisser. i like the chamber size just the way it is. I'm finding that, with the slight increase in airflow and the diff shape of the cap (diff from tailpiping), I'm doing less slip-streaming, and that's creating a fuller vape and a bit more flavor. So, I'm not wanting to reduce chamber size; as it would be too warm (with the reduced slipstreaming, I mean). Also, airflow is a bit less turbulent, because the "DT" hole being larger, less rim to circle the air; so I think it's a bit smoother too.
These coils are older/used, and just happen to be located where I always build them (i.e. not built special for this cap); but you can see that you nailed the custom airhole height perfect-like . . . where I like the center of the air hole aligned with the bottom of the coil, and I wanted to try bringing the air down just a little more than that.
thank you, Steve!
These coils are older/used, and just happen to be located where I always build them (i.e. not built special for this cap); but you can see that you nailed the custom airhole height perfect-like . . . where I like the center of the air hole aligned with the bottom of the coil, and I wanted to try bringing the air down just a little more than that.
thank you, Steve!
- Status
Similar threads
