901 atomizer hole

[MARK4567]

Ok I'm sure this has been thought of before..I personally find the draw on my 901 kinda hard compared to analogs. would drilling the hole in the side of the atomizer larger help??

thanks

Mark

 

[nicowolf]

It will make drawing air through the atomizer easier. The catch, is that it will make activating the automatic switch require more air through the atomizer. You have to create and maintain a vacuum in the battery cylinder to activate the switch. In order to create that vacuum, you will be sucking more air through the atomizer making the vapor thinner and less harsh. This is why so many of us like covering the atomizer hole partially or creating a pulse with our finger over the hole - to slow air flow and make activating the battery easier.

 

[jdm-chard]

could it be the battery switch thats making it hard to activate? they do tend to gunk up requiring more effort to turn it on.

 

[shoes]

You could try balancing your e-cig on end, after taking off just the filter end. After about 5 min. if there is a ring of liquid under it you probable have to much juice in it makeing it harder to draw.

 

[kinabaloo]

Liquid that escaped the inner cartridge and got between the inner and outer cartridge can cause a harder draw.

 

[secondson2929]

I have enlarged the hole on a 901 Att for better flow. It did work. However, when I tried a brand new attomizer I could hardly tell the difference. Since then I always just clean the att and it seems to do the trick.

*If you do enlarge the hole bake sure you don't drill past the outside casing so as not to damage the attomizer connection.*

Also I have found that there is sometimes a little paint in the hole. This can be cleaned up with the sharp end of a hobby knife.

 

[2kool2]

Yeah , I have tryed it too. Best just to clean your attomizer. I was getting to much air and just drilled it out the next size up.