So I've had a passthrough for the past few months...went to plug it in today (normally used typical USB power without issue, but finally broken down and bought the enercell wall plug).
Blue LED just stayed on...i've had this happen before...sometimes it was just the button being a little sticky. But today, no luck just stayed on.
I pop off the LED cover, and find that the ground wire is completely gone. Like, not disconnected from the solder, but GONE. and the whole inside is filled with a white glue to keep things from moving around. Not exactly the best quality passthrough.
So i'm looking to replace it. I like the fact that mine has no inline battery and runs at 5v. Definitely want one like that as well.
I also use 510 and carto's as well and it be nice to go between all of them with the same passthrough. I have adapters on the way for 510->901/carto and 901->510 and 901->carto.
So, other than the $60-80 range passthroughs, any good ones out there that are cheaper?
Blue LED just stayed on...i've had this happen before...sometimes it was just the button being a little sticky. But today, no luck just stayed on.
I pop off the LED cover, and find that the ground wire is completely gone. Like, not disconnected from the solder, but GONE. and the whole inside is filled with a white glue to keep things from moving around. Not exactly the best quality passthrough.
So i'm looking to replace it. I like the fact that mine has no inline battery and runs at 5v. Definitely want one like that as well.
I also use 510 and carto's as well and it be nice to go between all of them with the same passthrough. I have adapters on the way for 510->901/carto and 901->510 and 901->carto.
So, other than the $60-80 range passthroughs, any good ones out there that are cheaper?
