AFSv3 and Voltage issue

Status
Not open for further replies.

Outdated

Senior Member
ECF Veteran
Verified Member
Oct 27, 2010
157
32
SEA
Hi guys, previously my set up is 6v with normal 510atty, this works fine, not much leaking issue, even if there is probably only 1 drop out of the whole tank. Lately, i'm testing 510LR with 3.7v setup, i kept getting my collector tank filled with leakage from the center connector (i think it's because too much liquid getting into atty, i tried to give the control ring in the atty connector a quarter turn but doesn't solve the problem). My question is, is it necessary for AFS or AVS to run at 6v and above to make this work properly?
 
Status
Not open for further replies.

Users who are viewing this thread