Anyone made a single coil build in a Goliath?

[seanol]

I am using a TC mod and I have a long nickel coil between the posts. While it works I would like to just use one coil instead. Tried it and of course it flooded!

Anyone made and successfully wicked a single coil in the Goliath? Is there a way to plug the other air hole? I am guessing if I do I will lose the airflow.

Hoping this can be done as unless I go Ti for dual coils I am stuck with the coil spanning the middle. Reason I don't like that is it is a fairly long coil and I can't get it much over 2mm id before it comes really close to the posts.

Also, it makes putting it back together fsairly tricky. I love this tank, just want my cake too!

Thanks,
Sean

 

[Belhade]

Don't know how to close off the air hole, but just your luck! The V2 comes with a cover/cap for one air hole and half the deck so you can use one coil.

 

[seanol]

Wouldn't that cut off the airflow in the tank? If it as good as the Goliath for flavor I'll buy another one! Just want the airflow as well. My OG Subtank has a very tight draw, the Goliath is much better.
Thanks,
Sean

 

[Belhade]

I meant the Goliath v2; both versions have two airflow holes, one on each side of the deck, controlled by a ring around the base. So if one side is capped the other side still has its own air. This is how I use my Plume Veil with one coil; you can close off one air hole art a time.