Atmistique Atomizers

Status
Not open for further replies.

Kataphraktos

Vaping Master
ECF Veteran
Verified Member
May 1, 2013
3,241
10,032
New York, NY
OK, enough toying around. Next test: The Raqball Dilemma.

I just dug up some 2mm silica from my toolbox. Built a 1.3 ohm 30g R/NR coil, normal wrap (not microcoil). Instead of snipping a full silica strand on each side, I only removed 3 of the 5 threads of one strand, leaving a bit less than 1.5 strands of 2mm silica on each side. This left enough silica in the external slots of the v2 to completely cover the slots, much like I run my cotton wick.

So far, working fine in the Scuba. Tastes funny to me, though, like silica always did.

I've chosen Mother's Milk, a 50/50 juice, instead of my usual thick 100% VG juice, to mirror the juices most people vape.

I will run this in my Scuba first, make sure it works properly, and then swap it into my BB tomorrow.
 

qorax

ECF Guru
ECF Veteran
Verified Member
Mar 6, 2013
12,652
41,477
Brampton, Canada
www.facebook.com
Konstantine: when are the Golden Series Twins and Hippo v2 coming?

I just ordered a Provari Mini Stealth, and booked a time slot with my photographer friend.

I need to outdo qorax once before I die. :D

Did I hear someone calling me?



For my friend Dimitri :)
 
Last edited:

pmuniz10920

Super Member
ECF Veteran
Verified Member
May 7, 2013
514
956
Albuquerque, NM
Kimo every combination we test till now works just fine

pmuniz: the day we ship the order the same day Paypal send an email with the track number of your order. If you cant find it pls check also in your spam folder. Pls check your pm i send you again the track number

Yeah I recieved it, but I'm still under the impression usps likes messing with me.
 

Kataphraktos

Vaping Master
ECF Veteran
Verified Member
May 1, 2013
3,241
10,032
New York, NY
Silica and BB first run:

I recoiled using some 32g R, 30g NR, 3ohm coil wrapped around 2 strands of 2mm silica. Torched everything. Utterly generic install in the v2 Diver, just like the video. The only thing I did was to pull apart the silica threads on each side, so they would be spread out in each of the external v2 slots.

Vaped through half a tank since yesterday in the BB, working perfectly so far, using the v1 pin. As comparison, I had already built a similar setup, but with a 1.4 ohm coil in my other v2 in my Scuba on a Lux. I wanted to make sure I had a control against which to compare.

Flavor on silica in both setups is somewhat muted compared to cotton, though.
 
Status
Not open for further replies.

Users who are viewing this thread