Atty Cleaning a waste of time????
- Thread starter hogl3g
- Start date
- th_trl_thread_readers 0
- Status
i tried alot of atty cleaning techniques when i was a noob and non of them worked, but i finally found something that did.
fill a shot glass with isopropal alchole, dunk in the atty, cover the lid with plastic wrap and rubber bands, turn the cup over and shake it for 30 seconds or so, do this every few hours for a day, next day dry off atty, fill atty with VG and blow it out twice, then your good to go, atties like new. You will see a bunch of black little bits floating around in the left over alcohol, this is the carbonized juice that was stuck on the heating coil.
fill a shot glass with isopropal alchole, dunk in the atty, cover the lid with plastic wrap and rubber bands, turn the cup over and shake it for 30 seconds or so, do this every few hours for a day, next day dry off atty, fill atty with VG and blow it out twice, then your good to go, atties like new. You will see a bunch of black little bits floating around in the left over alcohol, this is the carbonized juice that was stuck on the heating coil.
I blow them out then toss them in my ultrasonic cleaner. Run it one cycle, blow them back out, run another cycle, blow out again then prime and vape. Prior to that, I just used hot water. Lost my first 510 atty after over 1 year of use.
- Status
Similar threads
