Bring the charger with. We have two dead batteries and one charger going on here. The source of the problem may not be the batteries.
ding ding ding...start looking at a common failure pointBring the charger with. We have two dead batteries and one charger going on here. The source of the problem may not be the batteries.
ding ding ding...start looking at a common failure point
Rare for two batteries to go kaput at the same time...
Took the charger. He tested it and the battery and it's fine.
He said the battery got charge but can't DO anything with the charge for some reason.
Uh-oh. That means a "something" tripped the internal protection on the battery. Can it happen spontaneously? Sure. But more likely is a problem device in the mix: A shorted carto, clearo etc. Or running LR devices - things in the 1.8 ohm range or lower. These things aren't designed for abuse - and LR stuff... that's abuse for eGo class batteries.
That all said, did you bring in the device you last used on both batteries for the store to check out? You put a device on one battery and it crapped out. You most likely then moved the same device to the next battery and.. it crapped out. If you don't have a volt/ohm meter you need to isolate that device and not use it until you can test it.
If it's an ego, I've heard that it will reset if you click the button 10 times in succession.... I've never had to do it, but give it a try.
Spinner still working so far after the 10 click "reset" thing.
Hmmmmm.....might be on to something.
hmm....once I saw the 10 click reset thing...straight to Google
Low and behold
Ego Battery Instructions - Hardware Instructions And Information
I don't see it on that page. None of the other stuff works, either, except the 5 push on/off.
Also saw a long 10 second hold down thing...but that may be a "burn" timeout or something
Do you have a multimeter to check if the unit is getting volts out to the center pin?
I think it was just off and your 10 clicky thing just turned it back on...
Ah... Here is where I heard about the 10 click thing...Spinner is still working like a champ!
This is good news to start passing around and I think the first place will be the B&M I picked the thing up at.