Green Leaf Pioneer4u ipv v2 50 Watt - BLACK & GRAY
$109.95
$104.45 after Newsletter VIP discount and more if you have any available Super VIP discount. All automatically calculated at checkout
Introducing the latest version of the ipv V2 50watt 18650 variable box mod with outstanding performance that provides ability to fine tune your vaping to nearly a perfect experience. You can adjust the wattage from 7w to 50w in increments of .1.
It is advertised to be able to fire coils as low as .2ohm but it is recommended to keep your sub-ohms at .5 or higher. Vaping lower than a .5ohm will void the warranty on this.
This utilizes a swappable 18650 battery (20amp or higher is recommended). You can remove the battery and charge or swap out or you can simply charge the battery with the battery remaining inside. If you do this on a USB port this can act as a pass-through. It is recommended though to remove the battery from the housing and reset from time to time to remove any built up static energy that can develop.
Easy to read OLED screen - measures and informs about wattage, resistance, output voltage and battery life at a glance - no cumbersome menus to navigate.
You also have a standard firing button on the side in addition to touch-plate sensor next to the 510 connection. This sensor allows the device to be fired just by resting a finger or thumb on it. The iPV V2 has 510 threading, but will accept any 510 to eGo adapter if you'd like to use eGo-threaded atomizers.
This mod is made of high-quality anodized aluminum.
- Attractively packaged.
- Micro-usb charging cable
- Extra cover screws - these are EXREMELY aeasy to drop so when opening the cover we recommend it is done over a towel or cloth of some sort.
- Small screwdriver
- Does not come with a battery but we recommend 20amp or higher.
Specs:
- Variable: 7W - 50W or 3.6V - 8.5V
- Input Current: 1.3A - 20A
- Input Voltage: 3.2V - 4.5V
- Efficiency: 93%
- Advertised 0.2Ω - 3.0Ω load resistance but we recommend .5 or higher.
- 0.96" OLED
- Safety Features Galore!
- Low Voltage Protection
- Low Resistance Protection
- High Input Voltage Warning
- Short Circuit Protection
- Reverse Battery Protection
This comes with a thorough manual but here are some highlights:
- Power On/Off: Click the firing button 5 times.
- Adjusting Wattage: Press the + or - button to increase/decrease wattage.
- Lock/Unlock: Click and hold both the + and - buttons simultaneously. The screen will indicate the lock/unlock status.
- Turn Touch Sensor On: Hold the + button and press the firing button.
- Turn the Touch Sensor Off: Hold the - button and press the firing button.
Last edited:
