AVS Tips and Technical Help
- Thread starter clyde2801
- Start date
- th_trl_thread_readers 0
- Status
no sorries EL. The only I wanted to hear is that you are satisfied. Good vaping
This thread has given me hope. May be getting an AVS sooner than I originally thought, especially if I can use 510 atty's. Thank you all
510 vapes even better because of the liquid control ring sparrots. Maybe AVS is your personal gift for Christmas
Can't wait for a 510 connector!
I Never did get that 901 connector from Rob, and I just sent back the one RippSpeed was gracious enough to let me borrow! I was just starting to get the hang of it too!
But I have all the Orings I need now (Thanks again, Justin), so if the post office decides to get their act together and deliver me a connector, I'll be good to go!
I Never did get that 901 connector from Rob, and I just sent back the one RippSpeed was gracious enough to let me borrow! I was just starting to get the hang of it too!
But I have all the Orings I need now (Thanks again, Justin), so if the post office decides to get their act together and deliver me a connector, I'll be good to go!
Well, I got my AVS w/510 this past week and got the guts to try it out this morning. Is it normal for it to be harder to draw than just the GGTS by itself. Have a lot of gurgling too. Tried to open up the CR more and got a handfull of juice. Thinking this is just the normal learning curve but looking for some reassurance and/or more tips.
Thanks!
Thanks!
Unsure with 510 as don't have the adapter. But..
Gurgling usually indicates juice in the collector tank, use a syringe to remove it. Maybe the adjustment on the 510 wrong too allowing too much juice(watch Imeos vids). Have the CR ring only open a bit and sort out why too much juice being fed. And make sure you have 100% seal everywhere, do the tops up tightly etc.
Gurgling usually indicates juice in the collector tank, use a syringe to remove it. Maybe the adjustment on the 510 wrong too allowing too much juice(watch Imeos vids). Have the CR ring only open a bit and sort out why too much juice being fed. And make sure you have 100% seal everywhere, do the tops up tightly etc.
I use to get alot of gurgling with a 901 atomizer, since switching to 808 carto's no gurgling at all. I found that the 808 carto gives it a better seal. As hope said check to make sure the seal is 100% otherwise the collector tank will fill with juice, giving you the gurgling.
Ill have to try a 510 at some stage , but i have to many 808 carto's to use. and 6.4 volt with 808 carto is my sweet spot
Ill have to try a 510 at some stage , but i have to many 808 carto's to use. and 6.4 volt with 808 carto is my sweet spot
I have the same problem, but it's with my 901 hv atty... I get a lot of gurgling whenever I puff it... I tried replacing the o-rings but still no luck... I always open my cr half way turn and I found out after few minutes that I got lots of juice in my Collector Tank... The first day I've got my hands on GG, I never had this problem... It started 3days ago after I cleaned my AVS... I don't really consider this as a big issue because I can always take out the liquid using a syringe whenever I get a chance... ^_^
Try cartos, the AVS/AFS has always had this issue with 901 atties. You can buy the 510 adapter and use 510 atties. People seem to have more success with the 510 atomizers.
Thanks. I'll purchase 510 connector once available... Honestly speaking I'm not a 901 atty fan... I was forced to use it because 901 connector is the only one available when I purchased my AVS, so I have no choice... Hope to get one soon from our supplier...
Last edited:
Yep 808 cartos are the go, need to make a hole in em I find (20 second job with a screw and hammer, quick tap).
But If suddenly flooding with 901 maybe not tight enough or put a bit of vaso on all the threads up there. It is to do with not having 100% vacuum or are you using a new type of 901?.
But If suddenly flooding with 901 maybe not tight enough or put a bit of vaso on all the threads up there. It is to do with not having 100% vacuum or are you using a new type of 901?.
CR is made to adjust liquid inside atomizer exept to adjust the way you inhale Jek. So open the CR totally and also fill the tank when its not attached on the GG. AVS doesnt have any prblems (like the first day you bought it) if you adjust it the right way.
@Hopefull, I am using new sets of 901 atomizer... I always apply Vaseline on its threads... I always tightly close everything, where I am having a hard time to detach it whenever I want to clean it...
@Imeo, I am doing that buddy... I don't know if the problem is my juice because it is thinner than the previous juice I used in my AVS, which is thicker... But today, I was lucky and found out that my CT has little juice on it... I guess I'm back on track... Thanks for the help guys...
@Imeo, I am doing that buddy... I don't know if the problem is my juice because it is thinner than the previous juice I used in my AVS, which is thicker... But today, I was lucky and found out that my CT has little juice on it... I guess I'm back on track... Thanks for the help guys...
The learning curve that AVS has its because you have to understand how it works. A major rule is that gurgling = you have to empty the CT and CR needs to be full open. I am glad that you are ok. Please feel free to ask anything no shame here mate
- Status
