AVS v2 juice not feeding.. help plz

[wigglr]

Hey all...

The AVS (v2) has been a blessing. But recently I have been having a lot of leaking due to the fact that the only way for me to get jucie to the atty is by slightly opening up the top cap.. without doing this I am not getting any juice in the atty regardless of how I tight I put the air control ring...

BTW ... the juice control ring is as open as possible.....

 

[imeothanasis]

check your atomizer wig. Its clogged for sure. Blow air from both sides of atomizer and then suck from its side holes. Clean your mouth with water, make a dry burn and try again

 

[wigglr]

It's a brand new atomizer. Changed it yesterday. But has done this w/ different atomizers

 

[imeothanasis]

what juice you use?

 

[fright88]

Probably a stupid question but did you make sure the holes in the atty lined up with the slots?

 

[wigglr]

Imeo, I use about 60-70% PG juice.

@Fright. Lol no it's not stupid. I did make sure....

I was going through in my head how I assemble my AVS. When I line up the holes of the atty with the slots, I tighten it so it is very tight. Should I loosen the atty up? Maybe this will help (but still keep ariholes lined up)

 

[fright88]

Normally I loosen the center post screw on the atty/carto I stop tightening when it is snug if the holes don't line up I back it off till they do. Then I adjust juice controll and tighten center post and finish filling and assembly. To be honest though I don't really like 510 Attys so I normally use cartos or 901 stuff

 

[Major]

I used my AVS with 510's as Fright describes. But I have to admit that my 510 usage was limited due to the superior pleasure for me personally using punched 808's and 901's.

 

[wigglr]

I only have a 510 adapter for my AVS's... but I will certainly try and loosen my atty up...
Thanks fright and major

 

[fright88]

The odd thing is I have almost the exact oposite problem you have. On 510 stuff I have to completely tighten the juice controll ring for most stuff. I have had a couple cartos that I needed it bairly cracked open.

 

[wigglr]

The odd thing is I have almost the exact oposite problem you have. On 510 stuff I have to completely tighten the juice controll ring for most stuff. I have had a couple cartos that I needed it bairly cracked open.

Well I think if you and I together assembled an AVS it would be perfect