Battery charge time???
- Thread starter 27fan
- Start date
- th_trl_thread_readers 0
- Status
, And my 
6 hours ! J/K J/K , they should almost be ready , normally 2-3 hours , they do work on a partial charge BTW !
A good thing to do is buy a extra set of batteries so you always have a fresh pair charged.
Shortly after I posted, they were charged.... Got real happy, plugged them into the buzz, put on carto..... NOTHING. Put on an atomizer, NOTHING, tried that atomizer on my 510, yep it works, then tried a different atomizer, NOTHING.
The buzz has a red light on, and when I activate te button, red goes out. NO blue light, on a review I saw, said while activated blue light on. PLEASE, PLEASE PLEASE Help
The buzz has a red light on, and when I activate te button, red goes out. NO blue light, on a review I saw, said while activated blue light on. PLEASE, PLEASE PLEASE Help
I replied to you in your other thread. It sounds like the lug wire is loose on the top cap.
OK look into the top cap , is there a screw in there ?? phillips head type ?? , If not check the bag it came in we have had some come loose during shipping lately . If so pull the top cap carefully there is a wire attached to it and make sure the bottom screw is tight , not lug nut tight just snug , then loosen the top screw 1/2 turn and put the top cap back on then tighten the top screw snug.
let me know what happens
let me know what happens
gfrank may have the answer 
Sometimes they do come loose in shipping. Carefully unscrew your top cap and ensure the screw underneath is tight. Be sure to hold the wire ring and not the wire when tightening.
EDIT : or what mike said seconds before me
Sometimes they do come loose in shipping. Carefully unscrew your top cap and ensure the screw underneath is tight. Be sure to hold the wire ring and not the wire when tightening.EDIT : or what mike said seconds before me
Thanks so much for your fast replies..... I took out the batteries, and tried a different set, (I ordered 2 extra sets), Thise had only been charging about 30 minutes, and those worked. I put the originals back on charger and we'll see, don't know if they are a bad set of batteries or not, will wait and see. However unit # 359 is up and running! *whew* Was freaking out ther for a bit.
Does it happen.... a bad battery or set of batteries? If so will they be replaced?
Does it happen.... a bad battery or set of batteries? If so will they be replaced?
Good to hear !! if it is a bad battery we will replace it ! it happens but not very often ,
DO you have a voltmeter handy ? if so test the voltage on them , it could be the charger as well so test the charger voltage it should be 4.2 volts
Also make sure the button on the side of your charger is set at 3.7 and not 3.0. If your charger doesn't have the side button then you're fine.
One of my new sets of batts doesn't want to work in my Pro but works fine in my Buzz Classic...go figure. Yes I've been too lazy to dig out my meter since we moved to check these new batts.
One of my new sets of batts doesn't want to work in my Pro but works fine in my Buzz Classic...go figure. Yes I've been too lazy to dig out my meter since we moved to check these new batts.
Bov try swapping the batteries from top to bottom. Sometimes the prot circuit is funny and they wont contact just right. Might be a little higher contact in one PV allowing it to work in one and not the other.
Thanks Rupp, I think I tried that already. I have all my batt sets marked but I don't remember which set it was now LOL. If I rotate a set into my Pro that doesn't want to work then I'll troubleshoot some more. I just keep all 4 sets rotating when my BC or BP needs a change.
- Status
