This may or may not have been mentioned on here but thought id post this anyway since I just discovered it.. lol
I always had a problem getting the green gunk cleaned out between the threading on the battery no matter how hard I wrap a swab, paper towl or anything around it and turn like theres no tomorrow.
I then tried using a pin and going around it but it was too time consuming..
So now, I bought those alcohol saturated prep swabs that diabetics use prior to injecting..
So after a normal cleaning, (those swabs are good for that too) I take a new swab and squeeze out the excess alcohol. I then center the battery under it and place a dead cartomizer over the swab press down and turning as if I am putting on a regular cartomizer but the swab is in between.. The battery came out as if it were just shipped to me...
Hope it comes in usefull to some of you..
I always had a problem getting the green gunk cleaned out between the threading on the battery no matter how hard I wrap a swab, paper towl or anything around it and turn like theres no tomorrow.
I then tried using a pin and going around it but it was too time consuming..
So now, I bought those alcohol saturated prep swabs that diabetics use prior to injecting..
So after a normal cleaning, (those swabs are good for that too) I take a new swab and squeeze out the excess alcohol. I then center the battery under it and place a dead cartomizer over the swab press down and turning as if I am putting on a regular cartomizer but the swab is in between.. The battery came out as if it were just shipped to me...
Hope it comes in usefull to some of you..