New member but been vaping close to 3 years. Made a wooden box mod once and it was a success.
Loved it so much I decided to give it another try using a box from digikey. Im using 18 gauge wires so
heated wires is not a problem. I wired the battery parallel so voltage wouldnt be overkill for my taste.
The only problem is im using these single battery holder wired them up - to - and + to + but somehow
the negative side will get too hot and the spring shrinks and melts off the holders. Is there anything
I missed on this? Im using an angel eye LED switch rated at 2A 36VDC. Is the problemreally my battery
holders? Im trying to purchase the dual holders from digikey tomorrow if this will solve this problem.
Help would be greatly appreciated. BTW the switch functions perfectly fine. Press the button led turns on
and coils get hot but after about the 4th try then contacts shrunk and circuit is not complete. need
help from the pros. thanks.
Loved it so much I decided to give it another try using a box from digikey. Im using 18 gauge wires so
heated wires is not a problem. I wired the battery parallel so voltage wouldnt be overkill for my taste.
The only problem is im using these single battery holder wired them up - to - and + to + but somehow
the negative side will get too hot and the spring shrinks and melts off the holders. Is there anything
I missed on this? Im using an angel eye LED switch rated at 2A 36VDC. Is the problemreally my battery
holders? Im trying to purchase the dual holders from digikey tomorrow if this will solve this problem.
Help would be greatly appreciated. BTW the switch functions perfectly fine. Press the button led turns on
and coils get hot but after about the 4th try then contacts shrunk and circuit is not complete. need
help from the pros. thanks.