- Status
Have you considered the rage squonk? It's not a 250c but the vast majority I have seen swear they are all the "rage". (I know, I know haha) Many people are buying multiples of them. Price is $100.
Thanks but I want to get the replay feature on my next mod. I have had a few DNA mods starting with the Darwin and like them a lot. The 75c, even though I vape under 75 w does not have enough power for making changes during replay.
Dave
Dave
Understood, I'm jonesing to try the replay also. I've begged and begged for the boxer but I think "She Who Must be Obeyed" is on to my I'll never ask for anything again trick.
I'm lucky. Mine lets me get things just so I will shut up for awhile. Also I remind her how much a pack of smokes cost. Good thing she is blonde and hasn't figured out I spend a small fortune on this stuff.
The thing I have against the boxer is it’s 3d printed and they simultaneously want such a gigantic pile of money for it. 3d printing plastic is by definition cheap plastic.
It melts at low temperatures and the object is not molded under pressure making it even weaker. I could understand if it was an inexpensive mod but they are the opposite. Unfortunately it is the only 250c squonker I know of.
It melts at low temperatures and the object is not molded under pressure making it even weaker. I could understand if it was an inexpensive mod but they are the opposite. Unfortunately it is the only 250c squonker I know of.
Hi Most of the time I am on temp with ss 316. I have it about 35 J, ( I use sx mini g ) When I use one of my tanks I have it about 60J. The 75c will still work but not as good. Most of my builds are 3 or 4 wires twisted then wrapped with a thinner wire and turn out around 0.15. Since I got the Daedalus Pro I just Clapton everything.
Dave
Dave
Hmmm.... I basically never vape above 30w or go below .25ohm so I suspect a dna75c will still work for me. Or am I being over hopeful?
It should work for you and it would work for me. The 250 will give it more room to adjust up or down to use replay mode. To be sure check out the evolve dna forum.
That would depend on what plastic is used. I did find a video but I didn’t watch it so it may or may not have the info you need. The title implies it does though
Sounds like. You may be able to find out what it is printed from which could give you a better idea of toughness. I do know from dealing with pvc electrical conduit that there is a temperature (quite cold, like -40f, I forget the actual number though) where it becomes ridiculously brittle and tends to shatter under any real pressure. Once you know the plastic type more info should be findable.
Whelp I just now ordered a therion bf so I guess we’ll see 
Lol I may have learned more from this thread than the op
Lol I may have learned more from this thread than the op
If you haven't used escribe before you are in for a treat. I think you have to download the EU version so you can get replay. It is on the evolve forum
Dave
Dave
I have not experienced that with high mass low Ω coils on a 75C. What you will get is 97% vs. 85% efficiency.
- Status
Similar threads
