Buzz 510 cap screw adjustment

[jmathers]

Just got my Buzz with 510 cap. Can the screw in the center be adjusted? When I screw in my 510 atty it protrudes about an 1/8" so the holes in the atty are completed exposed - looks kinda funky and gives too much air in the hit. I noticed that included with the screwdriver is a set of screws but they appear all the same size. Can I just tighten up the center screw so that it protrudes less and the atty can fit? I thought I read somewhere that this was not advised?

Jeff

 

[BuzzKill]

Jeff the 510 is a new cap for us and from all of the measurements I took of 510 attys the height it is at is an average ( a little on the high side , IMO being on the low side can cause a NO contact situation )
I have been working on a variable height center post design that will accommodate almost any depth .

It is NOT adjustable as is Sorry

 

[jmathers]

I ended up removing the screw and then re-screwing it back in. It seems to have seated properly without any overt tightening - just barely hand tight. And now it sits lower so the atty can fit properly. Everything is working just fine. Thanks for your help. Enjoying the Buzz thus far.

Jeff

 

[BuzzKill]

Humm it must have been loose ?? weird
As long as it is working for you thats what matters , I will have them check on the screws from now on ! ( we do a 100% inspection so this will get added to the list )

 

[Ionredline]

Sorry I have to chime in here a sec.On my 510 it seems to have a bit of a stiff draw unless I crank the atty back a hair.Not a big deal just thought I'd throw that out there.