Buzz Pro status update

Status
Not open for further replies.

mistinthewoods

Vaping Master
ECF Veteran
Feb 4, 2010
4,956
1,822
67
Brooklyn, MI
Mines always turning on its own the little tab/marker underneath the wheel is flush with the tube and the wheel protrudes 1/8" on my infinity the wheel stays put and is flush with the tube is this standard for the BP?

Sent from my DROID2 using Tapatalk

1/8"?? No. Not at all. Mine is barely 1/32" proud of the tube.
1/8"??? Are you sure? Did you measure it? I'm not sure they can even be mounted like that.
 

cosmic charlie

Super Member
ECF Veteran
Verified Member
Oct 12, 2010
414
194
Boise ID
1/8"?? No. Not at all. Mine is barely 1/32" proud of the tube.
1/8"??? Are you sure? Did you measure it? I'm not sure they can even be mounted like that.

If I put a dime flat on the tube the dial is flush with the dime 1/8"?

Sent from my DROID2 using Tapatalk
 

5cardstud

ECF Guru
ECF Veteran
Verified Member
Jan 1, 2010
22,746
50,647
Wash
I don't know how it's possible but the Buzz gives me the heat of 6v that use to get from my previous mod at lower voltage. I'm still using a 3.5ohm carto between 4.5-5v and getting the same heat I like. The consistency of the vape is my favorite thing by far. I have some 3ohm carto's I can use but I haven't bothered to try them. Loving the Buzz Pro!
It's because of the amount of 4.5 and 5volt current your getting. I notice that too from one mod to another set at the same voltage.
 

combat_medic

Full Member
Jul 8, 2010
49
60
PA, US
Spent some time reading here but so far I have not found or I just loopy from trying different setting one the BP the off switch in the tail cap. I know if I turn it out it loses contact with the tube about 1/8 turn out for a range of about 5 degrees but after that is is back on again. Setting it on the cap while off turns ut back on, I have a map tank so the flat bottom of both buzzes works great. Can any of you tell me if a) I am doing something wrong b) there is an issues with my device c) this is normal and I need to step away from the buzzes and let my juice count go down.
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
Spent some time reading here but so far I have not found or I just loopy from trying different setting one the BP the off switch in the tail cap. I know if I turn it out it loses contact with the tube about 1/8 turn out for a range of about 5 degrees but after that is is back on again. Setting it on the cap while off turns ut back on, I have a map tank so the flat bottom of both buzzes works great. Can any of you tell me if a) I am doing something wrong b) there is an issues with my device c) this is normal and I need to step away from the buzzes and let my juice count go down.

Medic we have some tubes that the anodizing was not perfect on and that causes the bottom switch to be funky , we have some new ones coming in about 10 days that will fix this problem so keep your eyes open I will announce them when they get here.
 

Rosco

Vaping Master
ECF Veteran
Dec 23, 2010
7,124
2,013
73
KCMO:>)
Spent some time reading here but so far I have not found or I just loopy from trying different setting one the BP the off switch in the tail cap. I know if I turn it out it loses contact with the tube about 1/8 turn out for a range of about 5 degrees but after that is is back on again. Setting it on the cap while off turns ut back on, I have a map tank so the flat bottom of both buzzes works great. Can any of you tell me if a) I am doing something wrong b) there is an issues with my device c) this is normal and I need to step away from the buzzes and let my juice count go down.

It doesn't make squat difference to me cuz I don't shut mine off permanently - Ever.
If I'm not pressing the button - it's off. My button gets lots of action.:thumb:
I like stepping into the Buzzes, not away. Guess we just have a connection - my Buzzes and I.:)
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com

moorea

Unregistered Supplier
ECF Veteran
Aug 11, 2009
6,868
7,355
55
Marion, MT
phiniac.com
ok, road tests have been confirmed. The buzz pro vapes like a BMW 7 series drives. (I own a 5 series) So, I went & test drove a 7 series today........just for kicks. :)

And I was thinking it vaped like the Audi R's or the TTS drive! :) Guess its all a matter of perspective!
 

Rosco

Vaping Master
ECF Veteran
Dec 23, 2010
7,124
2,013
73
KCMO:>)
Mine vapes like a friggin' Buzz Army Tank.jpg
 

Bovinia

Divine Bovine
ECF Veteran
Jul 17, 2010
14,449
50,826
65
South Carolina
It doesn't make squat difference to me cuz I don't shut mine off permanently - Ever.
If I'm not pressing the button - it's off. My button gets lots of action.:thumb:
I like stepping into the Buzzes, not away. Guess we just have a connection - my Buzzes and I.:)

I got Buzzed BIG time today! I was pruning MIL's snowball bush and got stung on the thumb by a yellow jacket and few minutes later I got stung on my ear by a hornet :( I sure like my purple Buzz's better!
 
Status
Not open for further replies.

Users who are viewing this thread