Changing flavors???

Status
Not open for further replies.

dshack

Unregistered Supplier
ECF Veteran
I've seen a dozen whys to clean an atomizer on YouTube. However, everyone says this is done for maintenance. No one mentions anything about changing from one flavor to the next.

What is a good method to get the flavor out of an atomizer so you can switch to a new juice?

Right now I'm vaping Fire & Ice Peach RY4 flavor! :p
 
Last edited:

Doberz

Super Member
ECF Veteran
Verified Member
Feb 19, 2010
530
64
NW Indiana
www.facebook.com
What I do is blow out the atty into a paper towel and dab a paper towel lightly into the atty. Then I pull out the old poly (if I'm reusing it) and run it under some warm water. Then I put the poly in a paper towel and squish it to absorb all the water. Then I rinse out the cart with warm water, making sure to get in the holes on the side. Then I blow out the cart and dab a paper towel in the hole where the poly goes.

So far the only flavor I had trouble getting out of my e-cig has been menthol. Everything else has been an easy 3 minute switch.
 

DC2

Tootie Puffer
ECF Veteran
Verified Member
Jun 21, 2009
24,161
40,974
San Diego
I agree with the previous posters about just blowing it out, and maybe cycling a new flavor or plain PG/VG through it.
But if you have a flavor that is hard to get out and doesn't go well with other flavors, then an alcohol bath might be the best bet.

Most people use pure grain alcohol, if they can get it.
But where I live you can't, and the highest proof vodka is the next best choice.

Personally, I just move from flavor to flavor, usually without even blowing the atomizer out.
But then most of my flavors are complimentary.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread