cleaning cartomizers

[bklyncat58]

ok I did the boil method and the hot water in the sink method and blew them out and let them sit to dry for a few days . now I'm getting a inhale but hardly no vapor . ? does this mean there dead please help. thanks

 

[keelalagirl55]

Sounds more like there was still water in the filler. If you are still getting something, the coil is still working.

 

[440BB]

Definitely need to dry them out more. Sitting by themselves can take a couple days. I balance them, battery connector end down, on a light bulb. Luckily, we have those dressing room lights in our basement bathroom, so I can do four at once! About 30 minutes should be enough.

Others often post that they use the oven at about 150 for about 30 minutes. I haven't tried it but it should speed this up for you too!

You may still need to gently open up the center hole, pushing up from the battery end with a needle or thin paper clip, to ensure good draw. You should be able to see light when looking through the tip end. Good luck!

 

[been there]

Also do the reverse taryn spin on them before drying , that will help a lot and shorten drying time.

 

[SnowDragon]

Bklyn...washing and drying is at the 4:50 mark, but the dissection of a burnt Carto is pretty interesting too.



(No Audio) Here I show how to Drip Refill and how many drops for which style Carto.



Hope that helps............

 

[grandpawrichard]

Awesome Videos Snow! It is always a pleasure to watch your videos because they are so well done and narrated! Thank you!

GPR