Cloud Contest: Prize 1 30ml or 2 15 ml Plus -Bear Hair- Wick.

Status
Not open for further replies.

mac63

ECF Guru
ECF Veteran
Verified Member
Aug 1, 2014
48,101
46,086
I decide to play a bit with this one. Found out that taking a selfie while holding a sign and blowing a cloud ain't easy. Then most of the cloud stays in the mask.

aDSCN0154_zps79ab13cb.jpg
 

Carolina Vapoor

Ultra Member
ECF Veteran
Verified Member
Apr 20, 2012
2,120
2,458
47
North Carolina, US
I don't know how you guys do that..my clouds are never that big but they would kick me out of the bar if I did that..haha!!

Most are using toppers with really airy draws on them. However you can get close to the same size as the one above that I did with my R91. If you are vaping something with a tighter draw then you have to allow additional air to be inhaled. The easiest way to do that is to leave a slight gap between your lips close to the drip tip rather than closing your lips tightly around it. Then you have to do a lung inhale (not mouth to lung.) Lung inhale is basically the same thing as taking a long deep breath but you do it a little slower.

Another thing if you are using a higher ohm coil then try pulsing it a couple time to warm it up and then do the constant fire and inhale.
 

readmylips

Unregistered Supplier
ECF Veteran
What is the house-blend for these juices? The drop-down doesn't seem to work. I would like my juice max-vg with 3mg nicotine.

The juice is pure Vg. The only other thing in the juice is Flavoring which is pg. The ratio changes from flavor to flavor depending on how much flavoring is used.

Drop down works fine. There is only one choice. lol.

RML
 

readmylips

Unregistered Supplier
ECF Veteran
A great. I'm excited to try it if I win the contest. But they should either put the options back in the dropdown to select a ratio or state that the 'house blend' is a heavy VG blend. Its good for everyone, not just the drippers, since many people still using tank-based atomizers might want thinner e-juices. And people pushing high wattage to a dripper are going to be in pain if there is too much PG.

I think on the main page it says that. I have to go look to see if it still does... But check out the main page and see if it looks to be clear enough. I am happy to rewrite it if you feel it is not clear enough. :)

RML
 
Status
Not open for further replies.

Users who are viewing this thread