I have been using the mh12210 3.7 v / 3400 mah , 18650 batts and they last for 2 days at around 12 watts.
Not KTM, but the 3100 is going to last quite a bit longer..................At lower wattage settings. It will Drain much more rapidly and could be easily damaged to pushed to higher output levels.
Know your application.![]()
I've always vaped around 12 watts give or take. Since getting the nano I'm easily 18 to 27 watts. Oh how the times have changed. [emoji106]So I would guess you don't recommend the efest 3100 battery ? I do vape at the lowest setting but who knows what the future brings. That may change if and when I upgrade to subtank nano...........
So I would guess you don't recommend the efest 3100 battery ? I do vape at the lowest setting but who knows what the future brings. That may change if and when I upgrade to subtank nano...........
I remove all hot glue and now you can see the clean build.
All connections are flawlessly and the big wires are Silicon wires.
I've always vaped around 12 watts give or take. Since getting the nano I'm easily 18 to 27 watts. Oh how the times have changed. [emoji106]
I was gonna say the opposite, that I hadn't increased from my usual 11-12 watts when I got the subtank mini. But in my case I wrapped a 1.8ohm coil on the rba deck. Tried the .5 prebuilt, didn't like it. Tried the 1.2, better, but I guess I wanted a smooth vape like my kayfuns. throat hit is the most important thing for me, but I don't like it hot. the subtank mini wicks significantly better than my kayfuns, and tastes a better than the FT erlkonigin mini clone, which has a weird background taste I can't get rid of, or possibly worsened in the attempt.
I'd like to know about the serial number thing too... most of the reports of failure are incomplete and I can't for sure determine if there are bad ones outside of 0002xxx. Thanks for the responses on the off-topic subtank/coil ohm thing; yes, I knowingly wrap my coils for lack of buck/downregulation and realize I wouldn't have to if I got an sxmini or something that went below 3.6v or 3.8 or whatever it is. At least my VS30 and cloupor go that low unlike my drawer-bound istick20's.
VS DNA30 does not have step down at all. The rDNA40 does.
Ok thanks. At least it tells you when not regulating by blinking the ohms readout right?
I know right. I haven't owned a ton of vv/vw devises but out of the ones I've had this one beats them all. Yes that includes the 1st run of the istick. This is so much better made then that batch. I won't comment on the 30 or 50 since I do not own one.Do we really know there are exactly 50? (I'm thinking less)
I call BS on the serial fairy tale.
Looking at another Mini (Subtank), I'm amazed how its huge insulator issue is consistently played down, while Cp mini is bashed and worried for even by people who never even touched it.
Do we really know there are exactly 50? (I'm thinking less)
I call BS on the serial fairy tale.
Looking at another Mini (Subtank), I'm amazed how its huge insulator issue is consistently played down, while Cp mini is bashed and ”worried for” even by people who never even touched it.