So I now have 3 Reo compatible rba's - Cyclone, eBaron, and and RM2. The cyclone is kicking the other two.
Not sure exactly why but I suspect the very long silica is part of it. The silica wraps around the posts and is at least 3-4 times the length of the RM2. I set it up with 32g kanthal and 2.5mm silica (came in at 1.5 ohms) and it is hitting as hard as a genesis with just as much flavor. Keeps blowing my mind. I can go 5-10 hits without squonking.
The eBaron is ok. I need to get the coil master and at this point I am still going at 2.0 ohms and I think it will be better with a lower ohm coil. It is large compared to the RM2 and the Cyclone.
The RM2 is probably in the middle. This actually surprises me given all the positive comments here so I may not have it setup right yet. I have had to re-coil it a couple times just to get it going right. The first coil started at 1.4 ohms when I set it up but shortly after using jumped up to 2.7 (???). I used 32g kanthal and 2.0mm silica with 4 wraps so it should not have been that high. The second coil kept giving me dry hits so I had to tweak it around so it would pull the liquid up better. I do have the coil aligned with the hole in the bottom. Now it is better but not as strong as the Cyclone. I have to squonk the RM2 every hit or two to keep it from giving me dry hits, I'd like to make the silica longer if I can figure out a way. I've done dozens of coils before without problems so I think it must be the way I have it setup. Still its a really good rba after tweaking.
I'm wanting another Cyclone really bad
.
Not sure exactly why but I suspect the very long silica is part of it. The silica wraps around the posts and is at least 3-4 times the length of the RM2. I set it up with 32g kanthal and 2.5mm silica (came in at 1.5 ohms) and it is hitting as hard as a genesis with just as much flavor. Keeps blowing my mind. I can go 5-10 hits without squonking.
The eBaron is ok. I need to get the coil master and at this point I am still going at 2.0 ohms and I think it will be better with a lower ohm coil. It is large compared to the RM2 and the Cyclone.
The RM2 is probably in the middle. This actually surprises me given all the positive comments here so I may not have it setup right yet. I have had to re-coil it a couple times just to get it going right. The first coil started at 1.4 ohms when I set it up but shortly after using jumped up to 2.7 (???). I used 32g kanthal and 2.0mm silica with 4 wraps so it should not have been that high. The second coil kept giving me dry hits so I had to tweak it around so it would pull the liquid up better. I do have the coil aligned with the hole in the bottom. Now it is better but not as strong as the Cyclone. I have to squonk the RM2 every hit or two to keep it from giving me dry hits, I'd like to make the silica longer if I can figure out a way. I've done dozens of coils before without problems so I think it must be the way I have it setup. Still its a really good rba after tweaking.
I'm wanting another Cyclone really bad

Last edited: