Derringer Clone or RM8

[Libbydude]

Hmm, I want one. Someone sent me a Tobecco clone of the Derringer, and I love it. I would love one on a Reo!

I strongly recommend that you get one. The rm8 is great. Little bit of juice turns up around the afc but nothing compared to using the standard rda.

 

[Papa_Lazarou]

Hmm, I want one. Someone sent me a Tobecco clone of the Derringer, and I love it. I would love one on a Reo!

Yes. Yes, you would.

 

[Blackboar]

I have a RM8 on my Grand and love it for its flavor and vapor production. Dual 1.5mm micros on 26g at 0.4ohms. My only problem is when I pull the topcap off to inspect my wicks, the inner ring flies off with it. I'm afraid one of these days, it'll fall off somewhere and I'll lose the inner ring.

 

[Mrs C]

I have a RM8 on my Grand and love it for its flavor and vapor production. Dual 1.5mm micros on 26g at 0.4ohms. My only problem is when I pull the topcap off to inspect my wicks, the inner ring flies off with it. I'm afraid one of these days, it'll fall off somewhere and I'll lose the inner ring.

The outer top cap should not be so loose that it would fall off. If it is you can either put a slightly thicker o ring on or a wrap of flat waxed dental floss under the existing o ring to tighten it up. If the inner ring is flying off rather than sticking to the inside of the outer cap you can use the same trick.

 

[Blackboar]

I'm going to try the dental floss. The
outer ring is quite secure. It's that inner ring that gives me trouble. Thanks Mrs C!