DNA 40 Clone Discussion

[Croak]

Anyone who can post some Pictures from the internals in the Vapor Flask clones from 3fvapes? I am happy With mine, but would have been Nice to replace the kx 40d With a genuine dna 40.

 

[squag]

Thanks croak!

I'm curious about one thing. Is it safe to adjust the positive pin of the battery connection to make the battery caps flush? Is the wire soldered directly to the adjustment screw so the wire twists at the same time as the screw?

 

[Croak]

Thanks croak!

I'm curious about one thing. Is it safe to adjust the positive pin of the battery connection to make the battery caps flush? Is the wire soldered directly to the adjustment screw so the wire twists at the same time as the screw?

Yeah, screw spins the wire.

 

[TheotherSteveS]

Nice one Croak! Hope it goes back together ok lol!

You going to swap out the 510 btw??

 

[Ian444]

Croak, what is that square white or cream coloured component on the board on the opposite end to the display ribbon?

Is it an onboard fire button that has been removed?

 

[cobalt327]

Looks like they didn't waste anything, the removed switch looks to have been reused remotely. Not saying that's a bad thing.

 

[Ian444]

Looks like they didn't waste anything, the removed switch looks to have been reused remotely. Not saying that's a bad thing.

Ahhh, I always thought it was something of substance, but it is where the fire switch was! On all the clones I have seen pics or vids of, that work, they all have that white square, therefore likely that they are all the same pcb from Kangxin (or whoever supplies Kangxin). A slight difference in splash screen is irrelevant, I can do that on my R/C transmitter, its often just data in the eeprom of the micro.

 

[cobalt327]

At least that's what it looks like to me. Might be a square piece of insulation put under the switch that we're seeing.

Question- Is changing the splash message something "we" can do?

 

[Ian444]

Not usually, can only be done if you know a bit about the micro used, and have a programmer and access to the right pins to reload the eeprom.