Does this matter on a battery?

[yovengo]

I rewrapped my battery, first time actually doing it. Just over exagerrating if this is a good wrap or safe even with 'wrinkles'.

 

[State O' Flux]

Unless you used a shrink wrap too large for the application, applying a bit more heat to the "wrinkled" area will pull them out, but... if they don't hang up or drag in the mod, it's not that big a deal... as a good coverage and fit on the ends is more important than on the length.

 

[smokinGAVIN]

Some mods have pretty tight fitting battery compartments. The wrinkles on the wrap may cause the battery to be too snug and that may even cause the wrap to tear or wear out.

 

[Marc411]

Try using a hair dryer on the wrinkle and it should tighten right up.

 

[VHRB2014]

It looks good, a little more heat on it should tighten it up. Its quite normal to be extra careful while doing this, and so that probably explains the wrinkles. Just a little more heat, maybe even using it, LOL.

 

[Robert Cromwell]

If it is an Efest it may get hot enough with use to shrink on down?

 

[Marc411]

If it is an Efest it may get hot enough with use to shrink on down?

LOL....

I just recycled all mine and replaced them with 25R's. I only had a couple but they did get warm even at .5 ohms if I vaped them a little hard. They only were loaded in the REO once, only time that mod got warm.

 

[crxess]

If it is an Efest it may get hot enough with use to shrink on down?

Best answer

 

[yovengo]

Unless you used a shrink wrap too large for the application, applying a bit more heat to the "wrinkled" area will pull them out, but... if they don't hang up or drag in the mod, it's not that big a deal... as a good coverage and fit on the ends is more important than on the length.

The positive and the negative are sealed good and I don't really feel anything loose in the middle of the battery just those slight wrinkles