Dripping?
- Thread starter Inedia
- Start date
- th_trl_thread_readers 0
-
- Tags
- bloog litecigusa vapor pro
- Status
You need a sealed manual battery (not all manuals are sealed) with an atomizer and drip tip
Some possibilities w/ slim ecigs:
KR808D-1 (only the Bloog,SmokelessImage Volt, Halocigs G6 manuals are fully sealed) w/ a standard resistance DSE901 atomizer and drip tip (LiteCigUSA.net)
Joye 510 manual with a 510 drip tip
----
For fat battery models and models - just about any model with an atomizer since almost all are sealed manuals and get a drip tip to fit its atomizer
Some possibilities w/ slim ecigs:
KR808D-1 (only the Bloog,SmokelessImage Volt, Halocigs G6 manuals are fully sealed) w/ a standard resistance DSE901 atomizer and drip tip (LiteCigUSA.net)
Joye 510 manual with a 510 drip tip
----
For fat battery models and models - just about any model with an atomizer since almost all are sealed manuals and get a drip tip to fit its atomizer
Dormouse nailed it !
Only thing I would add would be extra juice and a napkin to blow out your atty when you flood it. Takes a bit to figure out how many drips to add, and when to re-drip.
DON'T DRIP AND DRIVE !!!!!
Only thing I would add would be extra juice and a napkin to blow out your atty when you flood it. Takes a bit to figure out how many drips to add, and when to re-drip.
DON'T DRIP AND DRIVE !!!!!
Dripping takes a bit of patience and practice, but you'll love the flavor and there's much less waste then using carts or cartos.
Here's what I do for dripping with a basic 510 atty:
Start with 3-4 drops and let it rest for a few seconds so it can soak into the wick.
Vape until the flavor starts going flat and vapor production drops off.
Add 2-3 more drops and vape as above.
Continue in this manner until you are either done vaping for the day or you want to change flavors. When you want to change flavors, you can either vape the previous flavor to its end or blow out the atomizer and start at step one.
HTH!
Here's what I do for dripping with a basic 510 atty:
Start with 3-4 drops and let it rest for a few seconds so it can soak into the wick.
Vape until the flavor starts going flat and vapor production drops off.
Add 2-3 more drops and vape as above.
Continue in this manner until you are either done vaping for the day or you want to change flavors. When you want to change flavors, you can either vape the previous flavor to its end or blow out the atomizer and start at step one.
HTH!
Welcome. All i do is drip. I use a Cisco's 306 1.5ohm atty from Avid Vaper on my Silver Bullet. These produce a good amount of vaper with a 50/50 blend of PG/VG. I would recommend one of these. They are easy to take care of and work forever as long as you keep them nice and wet. I use about 4-5 drops of liquid. Be careful not to over-drip as you will make a mess out of your pocket or whatever you keep your Cig in. A good thing to have is a towel or napkin of some kind. It is inevitable that it is going to leak. When you fill your atty, try to do it down the side as opposed to straight down the middle. If you do this it will keep the liquid from blocking up in the middle of the atomizer and keep you from getting a mouth full of juice. Also, Clean your atomizers. i soak them in Everclear overnight at least once every two weeks. Make sure you blow out the booze before you add more juice. Vaporized everclear taste horrible.
Last edited:
The 306 atty fits directly onto the Ego and 510 battery thread and gives excellent taste and vapor. This is the most compact of dripper attys for the 510 family.
There's also a Little Dwarf 801 thread drip atomizer that's nice, but you have to use an adapter to fit the Ego/510 family.
There's also a Little Dwarf 801 thread drip atomizer that's nice, but you have to use an adapter to fit the Ego/510 family.
- Status
Similar threads
