Since these cartos are mass produced , my last bunch were too airy of a draw for me. So I did this and it works for me.
cut approx 3/16" piece of scotch/3m etc. tape. push an end into the inside ring of the screw fitting as seen in the picture, then work it around until it drops in. (you won't see it in there - if you do and it bothers you trim it thinner 8^) if the draw is too firm for you, clip 3/16 off the tape length. (it doesn't seem to matter if sticky side is facing in or out.) a side note - after removing the tape insert after 10mins of use - i was very surprised too see the amount of dirt the tape had trapped. yikes. I'm now back to enjoying my cartos
I hope this helps, Merry Christmas all.
http://i244.photobucket.com/albums/gg27/ssweeneytodd/009.jpg
http://i244.photobucket.com/albums/gg27/ssweeneytodd/010.jpg
http://i244.photobucket.com/albums/gg27/ssweeneytodd/012.jpg
My Best, Walt
cut approx 3/16" piece of scotch/3m etc. tape. push an end into the inside ring of the screw fitting as seen in the picture, then work it around until it drops in. (you won't see it in there - if you do and it bothers you trim it thinner 8^) if the draw is too firm for you, clip 3/16 off the tape length. (it doesn't seem to matter if sticky side is facing in or out.) a side note - after removing the tape insert after 10mins of use - i was very surprised too see the amount of dirt the tape had trapped. yikes. I'm now back to enjoying my cartos
I hope this helps, Merry Christmas all.
http://i244.photobucket.com/albums/gg27/ssweeneytodd/009.jpg
http://i244.photobucket.com/albums/gg27/ssweeneytodd/010.jpg
http://i244.photobucket.com/albums/gg27/ssweeneytodd/012.jpg
My Best, Walt
Last edited: