Hello, today I want to talk about how best the air flow of the nautilus, mini or mega it, because 'although it has four holes with a diameter of 0.9 mm, 1.1 mm, 1.4 mm, and 1.8 mm for me and' insufficient have a good shot of cheek normal.
Obviously this change will void the warranty on the product, but if like me you were disappointed by the air control very hard, even if put on the hole bigger touches you inhale deeply or well ...
sell / throw or you could modify it.
Surfing the net I found two solutions very simple actually:
1) You can remove the ring of the air control, attention and 'a somewhat delicate operation!
as you can see in thisvideo:
In practice you will have all 4 holes
at the same time, with marked improvement in general for flavor and watts.
2) Make a hole with the drill bit 3 mm; place the ring on the hole bigger and simply enlarging the pre-existing hole; chain obviously after the ring will become fixed and you will be unable to move more.
I personally have used the second method, and now I finally have a good shot of air from the cheek.
Among other things with these enhancements you can push a normal coil up to 13/14 watt.If you regenerate the coil even 30 watts with tc etc etc.And here you can have fun whit ni200 or ti.
Here is the link to which inspired me http://www.kickcigsnow.com/mizers/clearomizers/23-mm-and-larger/review-nautilus-1/nautilus-air-flow/
And that 'the result after drilling:
I hope that my post is helpful to others ... Greetings and good vaping .
Obviously this change will void the warranty on the product, but if like me you were disappointed by the air control very hard, even if put on the hole bigger touches you inhale deeply or well ...
sell / throw or you could modify it.
Surfing the net I found two solutions very simple actually:
1) You can remove the ring of the air control, attention and 'a somewhat delicate operation!
as you can see in thisvideo:
In practice you will have all 4 holes
at the same time, with marked improvement in general for flavor and watts.
2) Make a hole with the drill bit 3 mm; place the ring on the hole bigger and simply enlarging the pre-existing hole; chain obviously after the ring will become fixed and you will be unable to move more.
I personally have used the second method, and now I finally have a good shot of air from the cheek.
Among other things with these enhancements you can push a normal coil up to 13/14 watt.If you regenerate the coil even 30 watts with tc etc etc.And here you can have fun whit ni200 or ti.
Here is the link to which inspired me http://www.kickcigsnow.com/mizers/clearomizers/23-mm-and-larger/review-nautilus-1/nautilus-air-flow/
And that 'the result after drilling:
I hope that my post is helpful to others ... Greetings and good vaping .
Last edited:
