Nope. Same coil! I'm shuttling six in heavy use (two on while four lay in rest), plus three in light use. On the six rotating ones, I use them for about a week, then swap for the next two in line.
A couple of quick pulses, a steel brush, and a good rinse, and they're good to go. After they dry, I re-wick them and place them in the back of the line.
I'm trying to get a baseline of approximately how long these things CAN run, with minimal attention. I always check their resistance, and so far all are coming in at 1.2 or less.
I'm hoping I can fit some 1.5s in there once I move onto re-coiling. That will allow me to use them on my old Provis with plenty of working range. We shall see.
They've definitely already become my favorite coils ever, which was unexpected (big time too). I'm a fanboi.
DPL, I am using a 30g, 2.5mm, 5wr. = 1.7Ω in a 2.5 Provari, no problems in getting it in there.
Yes i can see why they last so long for you.
When i have to rebuild its because i distorted the coil when removing the cotton .
Often the cotton is replaced to get that clean refreshing taste.
Beforehand i just pulse the coil to clean only .The coils do not have a chance to get gunked up perhaps because of the 96+ PG DIY e-liquid only the cotton turns dark after a week and quickly replaced after the coil pulsing .
Mine is not the right way only the way that works for how i vape as we all have different formula's in the e-liquid % etc etc.
I also run a couple Amor's with 2.0Ω coils. So you can get a little higher ohm's if'n ya want.
My brother is coming by this week to pick up the Eggrolls and CLRs I bought for him to try. He was complaining about glass tanks though. How do the V1 eggrolls compare to the V2? The glass is more protected in the V1. Do they still take the CLRs? Is the airflow about the same?
I may just give him a silicone ring thingy to put on his eggroll. That should take care of it, I think.
Are the V1s just as good as the V2s? Do they taste the same? Have the same airflow?The V1 does take the CLR. Mine have survived drops from 2 to 4 feet on concrete. They're constantly falling over with a loud slap on my wooden surfaces with no ill effects so far. Tough little suckers! Can't speak for the other versions.
Are the V1s just as good as the V2s? Do they taste the same? Have the same airflow?
I try to avoid politics and religion when possible. People are so blasted sensitive now-a-days!
Naw it was more wrangled than a mop just squeezed. Wrapping a new coil is simple anyhoot.Did you test it? I ask because I messed one up SO badly that I was CERTAIN it was dead. It rang up at 1.1, and I've re-wicked it at least three times since. Still 1.1. LOOKS like kaka, but vapes like it's still new.
These bad boys are TOUGH too.
Naw it was more wrangled than a mop just squeezed. Wrapping a new coil is simple anyhoot.
You're making want to go rip one up just for fun.
CONTROL yourself, DP!!!
+1 for rebuilding a CLR coil for no reason!