- Status
I don't know much about the evic, but I have read about a couple of pv's having problems with the T3's even if they have ego threading. You may need to try a 510-ego adapter. I'm sure someone that knows more about evic's will chime in soon.
Mine working fine
I'd guess its just another issue with MT3
Nice and secure, normal draw
I'd guess its just another issue with MT3
Nice and secure, normal draw
I will bet your T3 is a copy not an original. Had this happen to another member.
The 3 holes on the Base of a kanger are 2/3 UP the base. I think you will have one with the holes very near the bottom of the base. The Ego threads block the holes.
Post what you see and if needed contact your retailer. If they give you a run around, find a new supplier.
Original Kanger works fine on an eVic - I'm using one now.
The 3 holes on the Base of a kanger are 2/3 UP the base. I think you will have one with the holes very near the bottom of the base. The Ego threads block the holes.
Post what you see and if needed contact your retailer. If they give you a run around, find a new supplier.
Original Kanger works fine on an eVic - I'm using one now.
I have serveral MT3s and they are really airy on my evic. I had to plug one of the holes in the coil base to get a tighter draw. But I'll tell you this, I have to pull the post out on the MT3 coil a little bit so it will work, otherwise it won't make contact with the center post on the evic.
I checked it, the holes are definitely 2/3 up. I really REALLY hope its not a knock off because I bought from a very reputable and highly recommended supplier. Maybe its just a bad head? I'll pick one up and hope for the best. Thanks for all the input though! 
Best of luck. I have probably 15 T3/MT3 and 10 T3 mini and haven't had anything like this happen. At least we know it SHOULD work fine with the eVic.
ETA - may I suggest you remove the Top cone of the eVic and align the Kanger beside the threads to see where the will sit. Should be just around the top 2/3 threads.
ETA - may I suggest you remove the Top cone of the eVic and align the Kanger beside the threads to see where the will sit. Should be just around the top 2/3 threads.
Last edited:
You might want to try the Kanger EVOD. Its a bottom coil like the T3/MT3, but smaller and with less expensive replacement heads.
It has a smooth metal base with three air holes, rather than the knurled base of the T3/MT3. So its easy to tape over one or two of the air holes of the EVOD if you want a less airy draw. The EVOD fits the eVic without an adapter.
I always disliked the knurled base of the T3s and MT3s. I'll be buying EVODs instead from now on.
Last edited:
IIRC - If I Recall Correctly. Especially common to be used when trying to cover up a vague guess, or when you are truly befuddled and trying to recall a fact
As always, opinions are subjective
As always, opinions are subjective
Thanks I'll have to get a few of them. Right now I just use the tip of a wooden toothpick to plug the whole and it works great. I've been rebuilding the MT3 coils to with kantal wire and silica wicks and they work great.
Evod has decent reviews
Tank is 1/3 smaller - holds less
Base is new 2 piece design
Same 3 hole design
Basically a T3 mini with minor changes
Tank is 1/3 smaller - holds less
Base is new 2 piece design
Same 3 hole design
Basically a T3 mini with minor changes
- Status
