I have an evic. I have one vivi nova that when I put it on it register's the ohms and acts like it's firing. However the coil never heats up to produce vapor. Also some times I put it on and it works just fine. I do not have this problem when putting it on my provari.
- Status
on a side note anyone else notice that the eVic says that the coil is higher than it should be? or is this perhaps more a manufacturing mix up? I bought 2.4s and they register at 3.2, i normally rewick them but was lazy and they were 8 bucks for 5
So does my provari, my zmax did too
Mine usually register about 2.7-2.9 for a marked 2.4ohm brand new but with juice.
the resistance drops down when you start using it. the only thing about eVic I dont like is in VW mode it does not automatically update resistance unless you put it into sleep mode then turn it back on again. I sometimes just leave it in VV mode.
My Roughstack is finicky about making contact on the positive terminal (the pieces in the middle of where you screw on your PV). In the past I've taken a paper clip or a safety pin and wiggled the post back and fourth until it edged out just a touch. Then I'd put it back on my PV and it would work just fine. It moves independently of the rest of the post so it can adjust to the unit you are using and sometimes it can get a little gummed up.
Hope that helps
eVic seems to have a problem in the vW setting. I went back to, and will stick with the vv.
interesting, mine does that. Have you updated to the latest firmware? I got mine yesterday and it updates the resistance everytime I change the tank/carto/whatever
I'm betting the evic will be pretty awesome after a few more revisions. I can't wait to see what they're like in another year or so.
My Roughstack is finicky about making contact on the positive terminal (the pieces in the middle of where you screw on your PV). In the past I've taken a paper clip or a safety pin and wiggled the post back and fourth until it edged out just a touch. Then I'd put it back on my PV and it would work just fine. It moves independently of the rest of the post so it can adjust to the unit you are using and sometimes it can get a little gummed up.
Hope that helps
had to do this with my EvoD BCC to get it to work on the eVic, however now I cant put my finger over the air holes on the bottom to make it less airy
- Status
