I think the 200 is discontinued? Just as well, the 250 is a direct replacement & has 2 amp charging. Really helpful with Lipos & USB charging 
I was hoping to see more of those 200's that said 250 on one side, they charged faster too... at least without data connection.I think the 200 is discontinued? Just as well, the 250 is a direct replacement & has 2 amp charging. Really helpful with Lipos & USB charging![]()
I could double check this again, but I believe both 75C and the 250C pulls 1A off of my computer ports. The dna Go pulls 800+ma too. While the 200 only pulls 500ma off of my computer port. I only got one DNA250 last week (a Wismec reuleaux DNA250 [bronze edition]). And I only hooked it up once and I seem to recall that one was pulling 1A from my computer port too.I was hoping to see more of those 200's that said 250 on one side, they charged faster too... at least without data connection.
Wow! Where did you get that one? Was that purchased separately from a mod? As it looks like it was never used yet, or someone did an excellent desoldering and clean up job.This is a 200 board that I was talking about, the other side looks like a 200. After a bit of searching it seems it had the same charging characteristics as a 200....0.5 and 1 amp. Referred to as a DNA200 v2, very limited run.
This I copied and pasted from Evolv's support site, these were generally RMA replacements. It's a new board. Fuse is on correct side, both 200 and 250 has it on the same side.Wow! Where did you get that one? Was that purchased separately from a mod? As it looks like it was never used yet, or someone did an excellent desoldering and clean up job.And I might be mistaken, but doesn't the DNA200 v1 have the fuse on the other side of the board?
My 200's pull .99 ampsI could double check this again, but I believe both 75C and the 250C pulls 1A off of my computer ports. The DNA Go pulls 800+ma too. While the 200 only pulls 500ma off of my computer port. I only got one DNA250 last week (a Wismec Reuleaux DNA250 [bronze edition]). And I only hooked it up once and I seem to recall that one was pulling 1A from my computer port too.
Wow impressive. What does your USB voltage report as up that high? My machines usually are reading 4.6v @ 1A and 5.04v unloaded.My 200's pull .99 amps
I have one at my cabin in the Blue Ridge. The whole thing, both antennas and the amp, are spread out in the attic. It makes the difference between sketchy (at best) and pretty solid signal. Just one indoor antenna, and it's a fairly good sized place.Still thinking about buying a cell booster but it seems from reviews that the interior antennas have very poor range, like 20ft. I would need a system with 3 interior antennas to have coverage throughout the house ($$$$).
I have one at my cabin in the Blue Ridge. The whole thing, both antennas and the amp, are spread out in the attic. It makes the difference between sketchy (at best) and pretty solid signal. Just one indoor antenna, and it's a fairly good sized place.