Are you trying to say you've had Vapemail
Well we know that new warehouse works and gearbest have got their act together
Marcus, i have most of mine set around 400° and the wattage between 20/30. I know Bob uses his differently, but that way didn`t work for me as i found it way too hotOh by the way @Brynglas
I did mention it
I'm off to watch the footy and when I come back I'm gonna have a mess about with the TC.What temp should I be looking for George.As its a new coil should I take the temp up slowly
Marcus, i have most of mine set around 400° and the wattage between 20/30. I know Bob uses his differently, but that way didn`t work for me as i found it way too hot![]()
Oh by the way @Brynglas

It's a bit confusing at the the moment.But I will crack it
I've got 40j at 400f and not much vapour.
Could it be a duff coil Marcus ? Them temps/watts should be throwing the vapour out, what tank are you using ?It's a bit confusing at the the moment.But I will crack it
I've got 40j at 400f and not much vapour.
I vape on a Yihi chip(joules) 420º,20J and i get loads of vapour (but it's thru' a Lemo2)

Could it be a duff coil Marcus ? Them temps/watts should be throwing the vapour out, what tank are you using ?
Okay, crown tank, with I presume the Ni-200 coils (0.15 ?) on top of what mod??The crown tank Ter.Ill have a proper look in the morning.Perhaps I'll read the instructions then![]()
I think he has got it on his new IPV D2 BobOkay, crown tank, with I presume the Ni-200 coils (0.15 ?) on top of what mod??
I normally vape at full 40w and anywhere between 400-450°F, if Joules and it goes up to 50J, then again same temps but between 40-50J, my Yihi is set to 50J and 450°F, but that's with the Velocity dual coil Ni-200 @ 0.11 ohms
Ah! yes of course, well the rest of the message still applies, I'd probably start at 400°F and 40J then up the Joules first until it is right or he hits 50J and if that's the case then up the temp to 420 then 450, he shouldn't need to go higher than that unless he likes really hot vapes.I think he has got it on his new IPV D2 Bob![]()
Ah! yes of course, well the rest of the message still applies, I'd probably start at 400°F and 40J then up the Joules first until it is right or he hits 50J and if that's the case then up the temp to 420 then 450, he shouldn't need to go higher than that unless he likes really hot vapes.
And the Zero, and VF mini are at 20 watts 400°Still using a Nautilus Mini with a VS 0.29 ohm Ni-200 coil at 420°F and 40w on my VF Mini & the Zero with Atlantis v1 0.15 ohm 400°F at 40wYeah, they all differ at the end of the day Bob. I still use my VF at 40 watts, 410° The crappy SMY is at full blastAnd the Zero, and VF mini are at 20 watts 400°
EDIT: 12 Mg juices![]()
@Brynglas, George, have been out to LSE Vape Meet and sold my v1 Tab for a pony (£25) inc battery![]()
Velocity
No difference at all that I could see, but selling mine meant I only paid £1.29 + battery for the one I have
I haven't opened my second one yet,what's the difference Bob?
Be nice if we had a few good vape meets in North Wales.
A new shop in Chester has a meet,once a month,but i think it's more to promote their product.