• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Fasttech Veterans

Status
Not open for further replies.

Brynglas

Vaping Master
ECF Veteran
Verified Member
Sep 22, 2014
4,561
6,449
ΩFlint MountainΩ
Flavour really. If it simply works I'd be fine - I'm a tootle puffer! The main thing is that there should be plenty of space for fitting a single coil - my stubby little elderly gnarled fingers need as little to do as possible (hence finger screws). It should be a doddle to set up if possible, and it shouldn't leak in my top pocket. It's a lot to ask but then I'm weird that way. Oh, and the cheaper the better - I don't need it to survive a nuclear attack or be "artistically" etched. I'd probably be wicking it with ekowool which shows you the kind of uber-basic set-up I'm looking at. Just two posts! Three would just confuse me. :)

I can't think of a dripper i could say 100% would not leak.Your best bet would be to go for one with top airflow.
And like i said the velocity style deck.Sounds silly, but your ideal dripper is a big ask,only because it's not what the market is asking for so probably isn't produced.:unsure:
 
  • Like
Reactions: e-pipeman

e-pipeman

Vaping Master
Supporting Member
ECF Veteran
Oct 16, 2008
5,430
5,594
Brown Edge, England
  • Like
Reactions: Bobw1951

Bobw1951

Vaping Master
ECF Veteran
Verified Member
Feb 23, 2014
6,890
9,913
London, UK
Yes, I think that type of thing is a simple solution.
Was leaning towards the mains powered one, but eventually, I won't need mains power for an ext. drive will I!?
I could keep the LaCie drive plugged into the mains and then into the Sabrent hub, and whatever new ext. drive I get just plugged into the hub! Then I can switch them off when not in use without pulling cables out.
Think that is the best way forward for you
Nice! Didn't notice that earlier ...I'll see if there's one with a longer lead first!
Doubt they do one with longer lead if that is being offered as an add-on, in fact if I didn't already have a card with 4 extra USB3 ports added to the 4 in my computer, that is probably what I would buy as well
 

Bobw1951

Vaping Master
ECF Veteran
Verified Member
Feb 23, 2014
6,890
9,913
London, UK
For a tootle puffer you would need to screw it right down so as to block the 2 large air holes, and then back it off slightly to close the smaller ones down slightly, problem is, that it is usually for dual builds, there is no way to block the other side. My personal recommendation would be to get the Aromamizer that George referred to earlier at Midlands vaping which is a 3 post and then get this to turn it into a 2 post one.
See here for the details on the Aromamizer: Aromamizer RDA Round,Aromamizer RDA


EDIT: Ignore deleted above, seems you can't change the decks on the RDA only the tank
 
Last edited:
  • Like
Reactions: e-pipeman

Brynglas

Vaping Master
ECF Veteran
Verified Member
Sep 22, 2014
4,561
6,449
ΩFlint MountainΩ
For a tootle puffer you would need to screw it right down so as to block the 2 large air holes, and then back it off slightly to close the smaller ones down slightly, problem is, that it is usually for dual builds, there is no way to block the other side. My personal recommendation would be to get the Aromamizer that George referred to earlier at Midlands Vaping which is a 3 post and then get this to turn it into a 2 post one.
See here for the details on the Aromamizer: Aromamizer RDA Round,Aromamizer RDA

I'd also say Bob,the Velocity does leak a little not a great deal, but i have seen evidence on mine.Enough to take it off the mod it was on and put it on one that cost less.(didn't want to be paying for a new sx350j board).
It's the two posts that Pipe wants is the snag,or i'd say get a Wotofo Sapor off FT.Top airflow,supposed to have good flavour.But it's a three post deck.
 

Bobw1951

Vaping Master
ECF Veteran
Verified Member
Feb 23, 2014
6,890
9,913
London, UK
I'd also say Bob,the Velocity does leak a little not a great deal, but i have seen evidence on mine.Enough to take it off the mod it was on and put it on one that cost less.(didn't want to be paying for a new sx350j board).
It's the two posts that Pipe wants is the snag,or i'd say get a Wotofo Sapor off FT.Top airflow,supposed to have good flavour.But it's a three post deck.
That's why I suggested getting the Aromamizer with the 3 posts from MV and then the 2 post deck from FT, it's airflow is near the top, and using the fitted cyclone style chimney bit means that he can do a single build, or can't you change the deck in the RDA????
 
  • Like
Reactions: e-pipeman

Brynglas

Vaping Master
ECF Veteran
Verified Member
Sep 22, 2014
4,561
6,449
ΩFlint MountainΩ
That's why I suggested getting the Aromamizer with the 3 posts from MV and then the 2 post deck from FT, it's airflow is near the top, and using the fitted cyclone style chimney bit means that he can do a single build, or can't you change the deck in the RDA????

I don't think you can change the decks on the drippers Bob,unlike the rdta.On the pics the neg posts look fixed.


4th FT order is in packaging so the SC coils must have come in early.:banana:
 
  • Like
Reactions: e-pipeman

Bobw1951

Vaping Master
ECF Veteran
Verified Member
Feb 23, 2014
6,890
9,913
London, UK
I don't think you can change the decks on the drippers Bob,unlike the rdta.On the pics the neg posts look fixed.


4th FT order is in packaging so the SC coils must have come in early.:banana:
Unfortunately the tanks didn't come in early and the coils are in the same order :(
 

Brynglas

Vaping Master
ECF Veteran
Verified Member
Sep 22, 2014
4,561
6,449
ΩFlint MountainΩ
I hope so, I've got 2 on order


Just checked MV Bob,they have stock.Would mean buying a couple of Velocity decks(but probably be cheaper than FT,overall).You could cancel the FT rdta's and your orders would probably ship. It's an idea anyway:unsure:
 
  • Like
Reactions: Bobw1951

terry w

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2012
8,666
10,916
Manchester UK

Pictor

Vaping Master
ECF Veteran
Verified Member
Jun 27, 2009
9,066
19,246
UK
Think that is the best way forward for you
Doubt they do one with longer lead if that is being offered as an add-on, in fact if I didn't already have a card with 4 extra USB3 ports added to the 4 in my computer, that is probably what I would buy as well
Pity the lead can't be detached and a longer one used with it rather than an extension! Suppose that would be too simple! :laugh:
I have two spare USB's on the front of the computer, four on the monitor, and two on an extension lead that I use for charging batteries/mods ...all are in the wrong places for regular/permanent use. The computer tower is actually on the bottom shelf of the computer trolley, and sideways so that the printer will sit beside it, and it also gives me access to the back when needed ...if I crawl under the desk!

Only on the three items listed?
:offtopic: Somehow I think this is going to be a bit expensive for a home storage solution: Store 360TB on a coin-sized quartz, for 14 billion years, thanks to 5D lasers - Pocket-lint
...and they call it 'Pocket-lint'! :rolleyes:
 
  • Like
Reactions: Bobw1951

Pictor

Vaping Master
ECF Veteran
Verified Member
Jun 27, 2009
9,066
19,246
UK
My FT order shipped today after I cancelled that one item! :)

Just looks like a load of code to me :laugh: As i said Trish, i`ll wait for my next doctor visit, and see what is said :)
I tried all sorts to get mine down when we had a GP making a fuss over 1 point! Seemed the harder I tried, the worse it became! :laugh:
It was up and down like a jack in the box when I was in hospital, and when I saw it higher, they just said not to worry about it ..and that they weren't!
 
Status
Not open for further replies.

Users who are viewing this thread